|
AMIS-30522 Datasheet, PDF (1/28 Pages) AMI SEMICONDUCTOR – Micro-stepping Motor Driver | |||
|
AMIS-30522 Micro-stepping Motor Driver
Data Sheet
1.0 Introduction
The AMIS-30522 is a micro-stepping stepper motor driver for bipolar stepper motors. The chip is connected through I/O pins and a SPI
interface with an external microcontroller. It has an on-chip voltage regulator, reset-output and watchdog reset, able to supply peripheral
devices. AMIS-30522 contains a current-translation table and takes the next micro-step depending on the clock signal on the âNXTâ
input pin and the status of the âDIRâ (=direction) register or input pin. The chip provides a so-called âspeed and load angleâ output. This
allows the creation of stall detection algorithms and control loops based on load-angle to adjust torque and speed. It is using a
proprietary PWM algorithm for reliable current control.
The AMIS-30522 is implemented in I2T100 technology, enabling both high-voltage analog circuitry and digital functionality on the same
chip. The chip is fully compatible with the automotive voltage requirements.
The AMIS-30522 is ideally suited for general-purpose stepper motor applications in the automotive, industrial, medical, and marine
environment. With the on-chip voltage regulator it further reduces the BOM for mechatronic stepper applications.
2.0 Key Features
⢠Dual H-Bridge for 2-phase stepper motors
⢠Programmable peak-current up to 1.6A using a 5-bit current DAC
⢠On-chip current translator
⢠SPI interface
⢠Speed and load angle output
⢠Seven step modes from full step up to 32 micro-steps
⢠Fully integrated current-sense
⢠PWM current control with automatic selection of fast and slow decay
⢠Low EMC PWM with selectable voltage slopes
⢠Active fly-back diodes
⢠Full output protection and diagnosis
⢠Thermal warning and shutdown
⢠Compatible with 5V and 3.3V microcontrollers
⢠Integrated 5V regulator to supply external microcontroller
⢠Integrated reset function to reset external microcontroller
⢠Integrated watchdog function
3.0 Ordering information
Table 1: Ordering Information
Part No.
AMIS-30522 ANA
Package
NQFP-32 (7 x 7mm)
Peak Current
1600mA
Temp. Range
-40°Câ¦..125°C
Ordering Code
Tubes
0C522-001-XTD
Ordering Code
Tapes
0C522-001-XTP
AMI Semiconductor â June 2007, M-20684-001
1
www.amis.com
|
▷ |