|
ARRIAGX_09 Datasheet, PDF (137/234 Pages) Altera Corporation – The ArriaTM GX family of devices combines 3.125 gigabits per second (Gbps) serial transceivers | |||
|
◁ |
Chapter 4: DC and Switching Characteristics
4â15
Operating Conditions
Table 4â14. Arria GX Device DC Operating Conditions (Part 2 of 2) (Note 1)
Symbol
Parameter
Conditions
Device
Min Typ Max Units
RCONF (4)
Value of I/O pin pull-up
resistor before and during
configuration
Recommended value of
I/O pin external pull-down
resistor before and during
configuration
Vi = 0, VCCIO = 3.3 V
Vi = 0, VCCIO = 2.5 V
Vi = 0, VCCIO = 1.8 V
Vi = 0, VCCIO = 1.5 V
Vi = 0, VCCIO = 1.2 V
â
â
10
25 50
kï
â
15
35 70
kï
â
30 50 100 kï
â
40 75 150 kï
â
50 90 170 kï
â
â
1
2
kï
Notes to Table 4â14:
(1) Typical values are for TA = 25 °C, VCCINT = 1.2 V, and VCCIO = 1.2 V, 1.5 V, 1.8 V, 2.5 V, and 3.3 V.
(2) This value is specified for normal device operation. The value may vary during power-up. This applies for all VCCIO settings (3.3, 2.5, 1.8, 1.5,
and 1.2 V).
(3) Maximum values depend on the actual TJ and design utilization. For maximum values, refer to the Excel-based PowerPlay Early Power Estimator
(available at PowerPlay Early Power Estimators (EPE) and Power Analyzer) or the Quartus® II PowerPlay Power Analyzer feature for maximum
values. For more information, refer to âPower Consumptionâ on page 4â25.
(4) Pin pull-up resistance values will be lower if an external source drives the pin higher than VCCIO.
I/O Standard Specifications
Table 4â15 through Table 4â38 show the Arria GX device family I/O standard
specifications.
Table 4â15. LVTTL Specifications
Symbol
Parameter
Conditions
Minimum
Maximum
VCCIO (1)
Output supply voltage
â
3.135
3.465
VIH
High-level input voltage
â
1.7
4.0
VIL
Low-level input voltage
â
â0.3
0.8
VOH
High-level output voltage IOH = â4 mA (2)
2.4
â
VOL
Low-level output voltage IOL = 4 mA (2)
â
0.45
Notes to Table 4â15:
(1) Arria GX devices comply to the narrow range for the supply voltage as specified in the EIA/JEDEC Standard, JESD8-B.
(2) This specification is supported across all the programmable drive strength settings available for this I/O standard.
Units
V
V
V
V
V
Table 4â16. LVCMOS Specifications
Symbol
Parameter
Conditions
Minimum
Maximum
VCCIO (1)
Output supply voltage
â
3.135
3.465
VIH
High-level input voltage
â
1.7
4.0
VIL
Low-level input voltage
â
â0.3
0.8
VOH
High-level output voltage
VCCIO = 3.0, IOH = â0.1 mA (2) VCCIO â 0.2
â
VOL
Low-level output voltage
VCCIO = 3.0, IOL = 0.1 mA (2)
â
0.2
Notes to Table 4â16:
(1) Arria GX devices comply to the narrow range for the supply voltage as specified in the EIA/JEDEC Standard, JESD8-B.
(2) This specification is supported across all the programmable drive strength available for this I/O standard.
Units
V
V
V
V
V
© December 2009 Altera Corporation
Arria GX Device Handbook, Volume 1
|
▷ |