AKD4563A Datasheet, PDF (9/26 Pages) Asahi Kasei Microsystems – Evaluation board Rev.A for AK4563A

ASAHI KASEI
[AKD4563A]
2. Control Software Manual
„ Set-up of evaluation board and control software
1. Set up the AKD4563A according to previous term.
2. Connect IBM-AT compatible PC with AKD4563A by 10-line type flat cable (packed with AKD4563A). Take care of
the direction of 10pin header. (This control software does not operate on Windows NT, therefore please operate it on
Windows95/98.)
3. Insert the floppy-disk labeled “AKD4563A Control Program ver 1.0” into the floppy-disk drive.
4. Access the floppy-disk drive and double-click the icon of “akd4563a.exe” to set up the control program.
5. Then please evaluate according to the follows.
„ Explanation of each buttons
(1) About AK4563A
1. [Port Setup] : Set up the printer port.
2. [Write default] : Initialize the register of AK4563A.
3. [Function1] : Dialog to write data by keyboard operation.
4. [Function2] : Dialog to evaluate IPGA and OPGA.
5. [Write] :
Dialog to write data by mouse operation.
(2) About AK4353
1. [MSB] : MSB justified for DIT mode in AK4353.
2. [LSB] : LSB justified for DIT mode in AK4353.
3. [I2S] : I²S compatible for DIT mode in AK4353.
Note 1. Evaluation mode of AK4353 and AK4563A is same mode.
Note 2. The default of AK4353 is MCLK=256fs and I²S compatible mode.
Note 3. MCLK of AK4353 is fixed to 256fs.
„ Explanation of each dialog
1. [Function1 Dialog] : Dialog to write data by keyboard operation
Address Box: Input register address in 2 figures of hexadecimal.
Data Box:
Input register data in 2 figures of hexadecimal.
If you want to write the input data to AK4563A, click “OK” button. If not, click “Cancel” button.
<KM064400>
-9-
’00/12