UG-572 Datasheet, PDF (9/20 Pages) Winchester Electronics Corporation – C JACK

EVAL-ADE7978EBZ User Guide
Troubleshooting SDP Detection
If the software does not detect the SDP-B board, the message
shown in Figure 12 is displayed.
UG-572
If this message appears, take the following steps:
1. Verify that the SDP Blackfin board is connected to the PC
using the USB cable.
The window in Figure 13 pops up on your task bar;
Windows will install any other necessary drivers.
2. Once the installation is complete, click Rescan.
3. When another window appears, check if the LED on the
board is flashing; if so, click Select.
Figure 12. Hardware Select Message
Figure 13. Installing Driver Software Message
Rev. 0 | Page 9 of 20