UG-572 Datasheet, PDF (11/20 Pages) Winchester Electronics Corporation – C JACK

EVAL-ADE7978EBZ User Guide
ALL REGISTER ACCESS
The All Register Access window, shown in Figure 15, allows
control over all the registers at one time. The Read/Write
Successful LED lights up when all registers are accessed.
• Exit returns to the main menu.
• Read All reads all the registers as displayed in the All
Registers table.
• Write All writes the data to the specified registers. The
data in a column is only written to the register in the
respective column; the register name cannot be changed.
• File Output specifies the path to save the register file to. A
new path can be either typed in or the yellow folder can be
clicked to search for a path.
• Save to File saves all registers to a .csv file.
• Load from File prompts you to choose a .csv file from
which to load all the registers.
• An error window (bottom, right) is available. If something
goes wrong, reset the board and try again.
UG-572
WAVEFORM SAMPLING
The Waveform Sampling window is shown in Figure 16.
• The left side of the window, labeled Channels, lists the
different waveforms that can be plotted. A maximum of
five consecutive plots can be chosen at one time.
• Run continuously plots the chosen waveforms in a window
the size of which is specified by Capture Time.
• Single captures the plot for the Capture Time specified
and keeps it displayed in the window.
• Exit returns to the main menu.
• File Output is used to export the waveform captured as a
.csv or .png file. The directory must be chosen by typing it
into the text box or clicking to the picture of a file folder.
• Triggering can be enabled to align the window to start at a
particular Level (the amplitude at which the left side of the
waveform is aligned) of a waveform chosen with Source
and Mode.
Figure 15. All Register Access
Figure 16. Waveform Sampling
Rev. 0 | Page 11 of 20