EVAL-AD7405FMCZ Datasheet, PDF (6/20 Pages) Analog Devices – Full featured evaluation board

UG-690
EVALUATION BOARD SETUP PROCEDURES
The EVAL-AD7405FMCZ connects to the EVAL-SDP-CH1Z
system demonstration platform. The EVAL-SDP-CH1Z board is
the controller board, which is the communication link between
the PC and the main evaluation board. Figure 2 shows a
photograph of the connections between the EVAL-AD7405FMCZ
daughter board and the EVAL-SDP-CH1Z board.
After following the instructions in the Software Installation
Procedures section, set up the evaluation and SDP-H1 boards
as detailed in this section.
Warning
The evaluation software and drivers must be installed before con-
necting the evaluation board and EVAL-SDP-CH1Z board to
the USB port of the PC to ensure that the evaluation system is
correctly recognized when it is connected to the PC.
Connecting the Evaluation and SDP Boards to a PC
1. Ensure that all configuration links are in the appropriate
positions (see Table 2).
2. Connect the EVAL-AD7405FMCZ board securely to the J4
FMC connector on the EVAL-SDP-CH1Z board.
3. The EVAL-SDP-CH1Z board requires an external power
supply adapter, which is included in the EVAL-SDP-CH1Z
kit. Connect this power supply to the dc barrel connector
labeled +12V_VIN on the EVAL-SDP-CH1Z board.
4. Connect the EVAL-SDP-CH1Z board to the PC via the
USB cable enclosed in the EVAL-SDP-CH1Z kit.
EVAL-AD7405FMCZ User Guide
Verifying the Board Connection
1. Allow the Found New Hardware Wizard to run after the
EVAL-SDP-CH1Z board is plugged into your PC. (If you
are using Windows XP, you may need to search for the
EVAL-SDP-CH1Z drivers. Choose to automatically search
for the drivers for the EVAL-SDP-CH1Z board if prompted
by the operating system.)
2. Check that the board is connected to the PC correctly
using the Device Manager of the PC.
a. Access the Device Manager as follows:
i. Right-click My Computer and then click Manage.
ii. A dialog box appears asking for permission to
allow the program to make changes to your
computer. Click Yes.
iii. The Computer Management box appears. From
the list of System Tools, click Device Manager.
b. Under ADI Development Tools, Analog Devices
SDP-H1 should appear (see Figure 11), indicating that
the EVAL-SDP-CH1Z driver software is installed and
that the board is connected to the PC correctly.
Figure 11. Device Manager:
Checking That the Board Is Connected to the PC Correctly
Disconnecting the EVAL-AD7405FMCZ Board
Caution
Always remove power from the EVAL-SDP-CH1Z or click the
reset tact switch (located alongside the mini-USB port) before
removing the EVAL-AD7405FMCZ daughter board.
Rev. 0 | Page 6 of 20