EVAL-AD7405FMCZ Datasheet, PDF (3/20 Pages) Analog Devices – Full featured evaluation board

EVAL-AD7405FMCZ User Guide
QUICK START GUIDE
Follow these steps to quickly evaluate the AD7405 ADC:
1. Install the evaluation software from the AD7405 product
page or from the included CD. Ensure that the EVAL-SDP-
CH1Z board is disconnected from the USB port of the PC
while installing the software. (The PC may need to be
restarted after the installation.)
2. Ensure that the various link options are configured as
outlined in Table 2.
3. Connect the EVAL-SDP-CH1Z board to the evaluation
board as shown in Figure 2.
4. Connect the EVAL-SDP-CH1Z board to the PC via the
USB cable. For Windows® XP, you may need to search for
the EVAL-SDP-CH1Z drivers. Choose to automatically
search for the drivers for the EVAL-SDP-CH1Z board if
prompted by the operating system.
UG-690
5. Power up the EVAL-SDP-CH1Z by inserting the 12 V dc
barrel jack (included with EVAL-SDP-CH1Z), into the barrel
connector labeled +12V_VIN on the EVAL-SDP-CH1Z.
6. Launch the evaluation software from the Analog Devices
subfolder in the Programs menu.
7. Connect an input signal via the VIN+, J1 connector.
Figure 2. EVAL-AD7405FMCZ (Left) Connected to the EVAL-SDP-CH1Z Board (Right)
Rev. 0 | Page 3 of 20