82-000760-01 Datasheet, PDF (26/44 Pages) Analog Devices – HPUSB USB and HPPCI Emulators

HPPCI JTAG I/O Voltage Detection
HPPCI-ICE Legacy/Auto Detection Mode
The factory default for the pod shown in Figure 1-4 is legacy mode. For
more information about available modes, refer to “Auto Detection Mode”
on page 1-14.
In order to modify the factory default setting, remove the four screws on
the bottom of the plastic enclosure. When opening the case, first remove
the top of the enclosure with the top facing up. This must be done to
ensure that the four light pipes used for the LEDs are not damaged. The
default pod setting is shown in Figure 1-5. To determine whether the
default setting of your HPPCI-ICE needs to be modified, refer to “Legacy
Mode (Factory Default Setting)”.
Figure 1-4. HPPCI-ICE Pod
1-12
HPUSB, USB, and HPPCI Emulators User’s Guide