82-000760-01 Datasheet, PDF (19/44 Pages) Analog Devices – HPUSB USB and HPPCI Emulators

Getting Started
Verifying Driver Installation and Attaching to an
Emulation Target
Before using your USB- or PCI-based emulator, verify that the driver
software is installed properly.
1. Open the Windows Device Manager and verify that the
HPUSB-ICE, HPPCI-ICE or USB-ICE appears under ADI Devel-
opment Tools as shown in Figure 1-1.
Figure 1-1. Verifying Driver Installation
2. Connect the 14-pin header side of the pod cable to the target board
via the debug interface. The 14-pin connector is keyed at pin 3 on
the pod cable to ensure that the cable sits correctly on the 14-pin
target emulation header. The target board should also have pin 3
keyed.
HPUSB, USB, and HPPCI Emulators User’s Guide
1-5