82-000760-01 Datasheet, PDF (20/44 Pages) Analog Devices – HPUSB USB and HPPCI Emulators

USB- and PCI-based Emulator Installation Tasks
 Do not connect or disconnect a USB emulator JTAG header,
whether powered up or not, to/from a powered target.
Applying Power to the Emulator is next.
Applying Power to the Emulator
The final step is to power up the emulator.
The following procedures apply to HP-USB and USB emulators only.
Powering up a USB-based emulator:
1. Apply power to target board.
2. Apply power to the emulator
3. If the emulator is not connected to the PC, connect the devices
with the USB cable as described in Verifying Driver Installation
and Attaching to an Emulation Target.
4. Invoke CrossCore Embedded Studio or VisualDSP++.
Powering down a USB-based emulator:
1. Shut down (exit) CrossCore Embedded Studio or VisualDSP++.
2. Disconnect the USB cable from the emulator and PC.
3. Power down the emulator.
4. Power down the target board.
 If the emulator has an “Enable/Power” LED, the power LED lights
green when power is applied. The power LED lights amber when
connected to a session or when the ICE Test utility is used.
If the emulator has an “Enable” LED only, the LED lights amber
1-6
HPUSB, USB, and HPPCI Emulators User’s Guide