PAC5223 Datasheet, PDF (31/67 Pages) Active-Semi, Inc – Power Application Controller

PAC5223
Power Application Controller
11.2.6. Analog Output Buffer (BUF)
A subset of the signals from the configurable analog signal matrix CASM can be multiplexed to the BUF6 pin for external
use. The buffer offset voltage can be minimized with the built-in swap function.
11.2.7. Analog Front End I/O (AIO)
Up to 10 AIOx pins are available in the device. In the analog front end I/O mode, the pin can be configured to be a digital
input or digital open-drain output. The AIOx input or output signal can be set to a data input or output register bit, or
multiplexed to one of the signals in the configurable digital signal matrix CDSM. The signal can be set to active high
(default) or active low, with VSYS supply rail. Where AIO6,7,8,9 supports microcontroller interrupt for external signals. Each
has two mask bits to prevent or allow rising or falling edge of its corresponding digital input to trigger second
microcontroller interrupt INT2.
11.2.8. Push Button (PBTN)
The push button PBTN, when enabled, can be used by the microcontroller to detect a user active-low push button event and
to put the system into an ultra-low-power hibernate mode. Once the system is in hibernate mode, PBTN can be used to
wake up the system. In addition, PBTN can also be used as a hardware reset for the microcontroller when it is held low for
longer than 8s during normal operation. The PBTN input is active low and has a 55kΩ pull-up resistor to 3V.
11.2.9. HP DAC and LP DAC
The 8-bit HP DAC can be used as the comparison voltage for the high-speed protection (HP) comparators, or routed for
general purpose use via the AB2 signal in the CASM. The HP DAC output full scale voltage is 2.5V.
The 10-bit LP DAC can be used as the comparison voltage for the limit protection (LP) comparators, or routed for general
purpose use via the AB3 signal in the CASM. The LP DAC output full scale voltage is 2.5V.
- 31 -
Rev 1.10‒January 28, 2016