|
A3P1000-1FGG144M Datasheet, PDF (1/181 Pages) Actel Corporation – Military ProASIC3/EL Low-Power Flash FPGAs | |||
|
v1.0
Military ProASIC3/EL Low-Power Flash FPGAs
®
with Flash*Freeze Technology
Features and Benefits
Military Temperature Tested and Qualified
⢠Each Device Tested from â55°C to 125°C
Firm-Error Immune
⢠Not Susceptible to Neutron-Induced Configuration Loss
Low Power
⢠Dramatic Reduction in Dynamic and Static Power
⢠1.2 V to 1.5 V Core and I/O Voltage Support for Low Powerâ
⢠Low Power Consumption in Flash*Freeze Mode Allows for
Instantaneous Entry To / Exit From Low-Power Flash*Freeze
ModeÆ
⢠Supports Single-Voltage System Operation
⢠Low-Impedance Switches
High Capacity
⢠600 k to 3 M System Gates
⢠Up to 504 kbits of True Dual-Port SRAM
⢠Up to 620 User I/Os
Reprogrammable Flash Technology
⢠130-nm, 7-Layer Metal (6 Copper), Flash-Based CMOS Process
⢠Live-at-Power-Up (LAPU) Level 0 Support
⢠Single-Chip Solution
⢠Retains Programmed Design when Powered Off
High Performance
⢠350 MHz (1.5 V systems) and 250 MHz (1.2 V systems) System
Performance
⢠3.3 V, 66 MHz, 66-Bit PCI (1.5 V systems) and 66 MHz, 32-Bit
PCI (1.2 V systems)
In-System Programming (ISP) and Security
⢠Secure ISP Using On-Chip 128-Bit Advanced Encryption
Standard (AES) Decryption via JTAG (IEEE 1532âcompliant)
⢠FlashLock® to Secure FPGA Contents
High-Performance Routing Hierarchy
⢠Segmented, Hierarchical Routing and Clock Structure
⢠High-Performance, Low-Skew Global Network
⢠Architecture Supports Ultra-High Utilization
Table 1-1 ⢠Military ProASIC3/EL Low-Power Devices
ProASIC3/EL Devices
ARM Cortex-M1 Devices1
A3PE600L
System Gates
VersaTiles (D-flip-flops)
RAM kbits (1,024 bits)
4,608-Bit Blocks
FlashROM Bits
Secure (AES) ISP2
600 k
13,824
108
24
1k
Yes
Integrated PLL in CCCs
6
VersaNet Globals
18
I/O Banks
8
Maximum User I/Os
270
Package Pins
PQFP
FBGA
FG484
Notes:
1. Refer to the Cortex-M1 product brief for more information.
2. AES is not available for ARM-enabled ProASIC3/EL devices.
Advanced and Pro (Professional) I/Osâ â
⢠700 Mbps DDR, LVDS-Capable I/Os
⢠1.2 V, 1.5 V, 1.8 V, 2.5 V, and 3.3 V Mixed-Voltage Operationâ
⢠Bank-Selectable I/O Voltagesâup to 8 Banks per Chip
⢠Single-Ended I/O Standards: LVTTL, LVCMOS 3.3 V /
2.5 V / 1.8 V / 1.5 V / 1.2 V, 3.3 V PCI / 3.3 V PCI-X, and
LVCMOS 2.5 V / 5.0 V Inputâ
⢠Differential I/O Standards: LVPECL, LVDS, BLVDS, and M-LVDS
⢠Voltage-Referenced I/O Standards: GTL+ 2.5 V / 3.3 V, GTL
2.5 V / 3.3 V, HSTL Class I and II, SSTL2 Class I and II, SSTL3
Class I and II (A3PE3000L only)
⢠I/O Registers on Input, Output, and Enable Paths
⢠Hot-Swappable and Cold-Sparing I/Os
⢠Programmable Output Slew Rate and Drive Strength
⢠Programmable Input Delay (A3PE3000L only)
⢠Schmitt Trigger Option on Single-Ended Inputs (A3PE3000L)
⢠Weak Pull-Up/-Down
⢠IEEE 1149.1 (JTAG) Boundary Scan Test
⢠Pin-Compatible Packages across the Military ProASIC®3EL
Family
Clock Conditioning Circuit (CCC) and PLL
⢠Six CCC Blocks, One with Integrated PLL (ProASIC3) and All
with Integrated PLL (ProASIC3EL)
⢠Configurable Phase Shift, Multiply/Divide, Delay
Capabilities, and External Feedback
⢠Wide Input Frequency Range 1.5 MHz to 250 MHz (1.2 V
systems) and 350 MHz (1.5 V systems)
SRAMs and FIFOs
⢠Variable-Aspect-Ratio 4,608-Bit RAM Blocks (Ã1, Ã2, Ã4, Ã9,
and Ã18 organizations available)
⢠True Dual-Port SRAM (except Ã18)
⢠24 SRAM and FIFO Configurations with Synchronous
Operation:
â 250 MHz: For 1.2 V Systems
â 350 MHz: For 1.5 V Systems
ARM® Processor Support in ProASIC3/EL FPGAs
⢠ARM Cortexâ¢-M1 Soft Processor Available with or without
Debug
A3P1000
M1A3P1000
1M
24,576
144
32
1k
Yes
1
18
4
154
A3PE3000L
M1A3PE3000L
3M
75,264
504
112
1k
Yes
6
18
8
620
PQ208
FG144
FG484, FG896
â A3P1000 only supports 1.5 V core operation.
Æ Flash*Freeze technology is not available for A3P1000.
â â Pro I/Os are not available on A3P1000.
August 2008
i
© 2008 Actel Corporation
|
▷ |