X9118_14 Datasheet, PDF (11/17 Pages) Intersil Corporation – Single Digitally-Controlled Potentiometer

X9118
DC Operating Specifications T_A = +25°C, unless otherwise noted. Boldface limits apply across the operating temperature range ,
-40°C to +85°C.
SYMBOL
PARAMETER
TEST CONDITIONS
MIN
MAX
(Note 10) TYP (Note 10) UNITS
I_CC1 V_CC Supply Current (Active)
f_SCL = 400kHz; V_CC = +5.5V; SDA = Open;
(for 2-wire, Active, Read and Volatile Write States only)
3
mA
I_CC2 V_CC Supply Current (Nonvolatile Write) f_SCL = 400kHz; V_CC = +5.5V; SDA = Open;
(for 2-wire, Active, Non-volatile Write State only)
7
mA
I_SB V_CC Current (Standby)
V_CC = +5.5V; V_IN = V_SS or V_CC; SDA = V_CC;
(for 2-wire, Standby State only)
15
μA
I_LI Input Leakage Current
V_IN = V_SS to V_CC
10
μA
I_LO Output Leakage Current
V_OUT = V_SS to V_CC
10
μA
V_IH Input HIGH Voltage
V_CC x 0.7
V_CC + 1
V
V_IL Input LOW Voltage
-1
V_CC x 0.3 V
V_OL Output LOW Voltage
I_OL = 3mA
0.4
V
NOTE:
10. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
Endurance and Data Retention
PARAMETER
Minimum Endurance
Data Retention
MIN
100,000
100
UNITS
Data changes per bit per register
years
Capacitance
SYMBOL
C_IN/OUT
(Note 11)
C_IN (Note 11)
TEST
Input/Output Capacitance (SI)
Input Capacitance (SCL, WP, A1 and A0)
TYP
8
6
UNITS
pF
pF
TEST CONDITIONS
V_OUT = 0V
V_IN = 0V
Power-Up Timing
SYMBOL
PARAMETER
MIN
MAX
UNITS
t_r V_CC (Note 11) V_CC Power-up Rate
0.2
50
V/ms
t_PUR (Note 12) Power-up to Initiation of Read Operation
1
ms
t_PUW (Note 12) Power-up to Initiation of Write Operation
50
ms
NOTES:
11. This parameter is not 100% tested.
12. t_PUR and t_PUW are the delays required from the time the (last) power supply (V_CC-) is stable until the specific instruction can be issued. These
parameters are periodically sampled and not 100% tested.
AC Test Conditions
Input Pulse Levels
Input Rise and Fall Times
Input and Output Timing Level
V_CC x 0.1 to V_CC x 0.9
10ns
V_CC x 0.5
Submit Document Feedback 11
FN8161.5
April 9, 2014