Z51F6412 Datasheet, PDF (26/54 Pages) Zilog, Inc. – Power supply level that can be adjusted with potentiometer R20

Z51F6412 Development Kit
User Manual
19
Build and Run the Z51F6412 Demo
Project
Observe the following procedure to build and run the Z51F6412 demo project.
Note: If you plan to use the Keil µVision IDE, please skip to the the Using the Keil µVision IDE
on a Demo Project section on page 25.
1. Browse to the following location and double-click the build_sdcc.bat batch file to
build the project:
<Z8051 Installation>\Z8051_<version_number>\samples\Z51F6412\Demo\build_sdcc.bat
Note: Refer to the Z8051 Tools Product User Guide (PUG0033) for additional information about
these project files and Small Device C Compiler (SDCC) development tools.
2. When the build is complete, the command window will prompt the user to press any
key to continue. Proceed by pressing any key on your keyboard; as a result, a hex file
for the demo will be created in the following path:
<Z8051 Installation>\Z8051_<version_number>\samples\Z51F6412\Demo\demo.hex
3. Set up the OCD and Development Board. If you have not already configured these
items, please return to the Configure the Z8051 OCD and Z51F6412 Development
Board section on page 16.
4. Run the Z8051 OCD software. From the Start menu, navigate to All Programs →
Zilog Z8051 Software and Documentation <version_number> → Zilog Z8051
OCD <version_number>. Once launched, the program will display Connected, as
shown in Figure 16.
Note: If you encounter a message that says Disconnected, return to the Configure the Z8051
OCD and Z51F6412 Development Board section on page 16 to configure the proper
power-up sequence. If the problem persists, Zilog recommends that you review the Z8051
OCD Driver Installation and FTDI USB-to-UART Driver Installation sections.
UM025901-1112
Build and Run the Z51F6412 Demo Project