|
Z51F6412 Datasheet, PDF (23/54 Pages) Zilog, Inc. – Power supply level that can be adjusted with potentiometer R20 | |||
|
◁ |
Z51F6412 Development Kit
User Manual
16
Configure the Z8051 OCD and Z51F6412
Development Board
Observe the following procedure to set up and configure the Z8051 On-Chip Debugger
and the Z51F6412 Board.
Caution: Steps number 1 to 4 present the power-up sequence. Carefully follow these steps to avoid
encountering an improper connection or disconnection.
1. Connect the Z8051 On-Chip Debugger (OCD) to the host PCâs USB port.
2. Connect one end of the 10-circuit cable to the Z8051 OCD.
3. Connect the other end of the 10-circuit cable connector to the Boardâs J3 connector.
Pin 1 of the cable connector is indicated by a red stripe, as shown in Figure 13.
Figure 13. Connecting the 10-Circuit Cable to the Board
UM025901-1112
Configure the Z8051 OCD and Z51F6412 Development
|
▷ |