Z8F2480 Datasheet, PDF (12/24 Pages) Zilog, Inc. – Load current up to 3 amps

Z8F2480 Power Monitor with an eZ80F91 Webserver
Reference Design
Persons working with this reference design should be fully qualified to work with high
voltage devices.
Recompiling the Power Monitor Software
The Power Board is delivered with software installed and ready to use. The source code is
available in the RD0027-SC01.zip file that is included with this reference design; modifi-
cations to this software are not expected to be required. However, should you prefer to
make changes and/or learn more about how the software operates, you must obtain a copy
of the ZDS II for Z8 Encore! Integrated Development Environment before being able to
modify the software and reprogram the Power Board.
Observe the following procedure to download and install the ZDSII software.
1. Download the latest version of ZDSII – Z8 Encore! from the Downloadable Software
category of the Zilog Store.
2. Run the software installation file and follow the on-screen instructions to install
ZDS II – Z8 Encore!.
To recompile the Power Board software, observe the following procedure:
1. Launch the ZDSII – Z8 Encore! program by navigating via the Windows Start menu
to All Programs → Zilog → ZDS II_Z8Encore! <version_number> →
ZDSII_Z8Encore! <version_number>.
2. From the File menu, select Open Project to display the Open dialog box.
3. In the Open dialog, browse the following default installation filepath:
C:\Program Files (x86)\Zilog\ZRD0027PLM0ZRD_1.0\Firmware\Src
4. From the Src folder, select the RD0027.zdsproj file, and click Open to display the
initial ZDS II program screen. To view the source files, double-click the Project Files
folder on the left side of the IDE interface. Double-click an individual file to open the
file in the ZDS II file editor.
5. Click the Rebuild All toolbar icon (indicated in Figure 7). When the build completes,
a Build Succeeded message will appear.
RD002702-0814
Page 12 of 24