C01 Datasheet, PDF (12/12 Pages) Powerbox – 1 WATTS 100-8KV SINGLE OUTPUT DC/DC INDUSTRIAL

BLOCK DIAGRAM
C SERIES
HOW TO ORDER
PART NUMBER SELECTOR:
Model Number:
C 10 N FL
Model
Output Voltage (See Table)
Flying Lead (Optional) (Blank or FL)
Polarity Designator (Blank or N)
EXAMPLE: C10N (C-Series, 10 - Output Voltage, N - Negative, FL - Flying Lead (Optional)
* Notes:
1. At maximum rated output voltage.
2. Specifications after 1 hour warm-up, full load, at 25°C unless otherwise indicated.
3. Typical performance
4. All grounds internally connected except case. There should not be more than 50 volts potential between the case ground (pin 5) and the circuit ground (pins 3 and 8). Isolated case assists low-noise
design efforts. Case pin must be connected to ground for proper operation.
5. Proper thermal management techniques are required to maintain safe case temperature at maximum power output.
6. SET-POINT ACCURACY refers to the ability of the unit to accurately deliver the voltage intended by the applied programming. The resultant output voltage will be within +/-1% of that programmed.
GAIN ADJUSTMENT refers to the ability to alter the gain of the circuit to bring the resultant output voltage to the programmed set point. This is intended to allow compensation for set-point accuracy error.
LINEARITY refers to how much the transfer function can deviate from a straight line in the absence of any set-point error.
XP-EMCO reserves the right to make changes on products and literature, including specifications, without notice. XP-EMCO standard product models are not recommended for “copy-exact” applications
or any other application restricting product changes. “Copy-exact” options are available. Please contact an XP-EMCO sales representative for more details.
WWW.XPPOWER.COM
4711CR
PAGE 12