C01 Datasheet, PDF (11/12 Pages) Powerbox – 1 WATTS 100-8KV SINGLE OUTPUT DC/DC INDUSTRIAL

CM4: MODELS C50, C50N, C60, C60N, C80 and C80N
C SERIES
LGH
MATING
CONNECTOR
1.40 (35.56)
.75 (19.05)
LGH
OUTPUT
CONNECTOR
1.312
(33.32)
.24 (6.09)
TOP VIEW
6.77 (171.96)
MTG HARDWARE
SUPPLIED
15S SUB-MIN 'D'
RECEPTACLE
AMP # 747909-2
1.80
(45.72)
8 ₁₅
SOLDER
CUP SIDE
19
5.25 (133.35)
3.80 (96.52)
1.30
(33.02)
GAIN
ADJUST
3.700 (93.98)
#4-40 MTG HOLE
4 PLACES
.50
(12.7)
15P SUB MIN-D
PLUG (MALE)
AMP # 747841-4
.05 (1.27)
THICK
.85 (21.59)
1.312
(33.32)
ANODIZED
ALUMINUM
MOUNTING PLATE
Dimensions are in inches (metric equivalents are in parentheses)
Dimensional tolerances: .xx +/- 0.02 (0.51mm)
.xxx +/- 0.005 (0.127mm)
PRPORDOUDCUTCDT EDSECSRCIRPITPIOTINON
These adapters provide convenient prototyping and evaluation during
system development and integration. They allow C Series modules to
be mounted to a chassis instead of designed into a PC board.
Extra filtering on the input and output improves performance. A schottky
diode on the input provides reverse polarity protection. Input connector
is via a 15P SUB MIN-D plug (mate supplied) and output is via an LGH
style coaxial connector (mate supplied).
ORDERING INFORMATION:
Please note when ordering a CM4 the C Series is not included and must
be ordered separately.
PROGRAMMING INSTRUCTIONS
• Onboard Potentiometer: connect pins 7 to 4 and 8 to 3, turn
potentiometer to adjust high voltage.
OR
• Remote Potentiometer: connect wiper arm to pin 3, other sides
to pins 4 and 2.
OR
• Remote Analog Signal: apply programming voltage to pin 3,
return to pin 2.
WWW.XPPOWER.COM
4711CR
PAGE 11