C01 Datasheet, PDF (10/12 Pages) Powerbox – 1 WATTS 100-8KV SINGLE OUTPUT DC/DC INDUSTRIAL

CM3: MODELS C25, C25N, C30, C30N, C40 and C40N
C SERIES
SHV
MATING
CONNECTOR
1.33
(33.78)
.90 (22.86)
SHV
OUTPUT
CONNECTOR
1.300
(33.02)
.25 (6.35)
#4-40 MTG HOLE
4 PLACES
TOP VIEW
5.00 (127.00)
MTG HARDWARE
SUPPLIED
15S SUB-MIN 'D'
RECEPTACLE
AMP # 747909-2
1.80
(45.72)
8 ₁₅
SOLDER
CUP SIDE
19
3.83 (97.28)
2.33
(59.18)
GAIN
ADJUST
.50
(12.7)
15P SUB MIN-D
PLUG (MALE)
AMP # 747841-4
.05 (1.27)
THICK
.82 (20.83)
1.312
(33.32)
2.200 (55.88)
ANODIZED
ALUMINUM
MOUNTING PLATE
Dimensions are in inches (metric equivalents are in parentheses)
Dimensional tolerances: .xx +/- 0.02 (0.51mm)
.xxx +/- 0.005 (0.127mm)
PRPORDOUDCUTCDT EDSECSRCIRPITPIOTINON
These adapters provide convenient prototyping and evaluation during
system development and integration. They allow C Series modules to
be mounted to a chassis instead of designed into a PC board.
Extra filtering on the input and output improves performance. A schottky
diode on the input provides reverse polarity protection. Input connector
is via a 15P SUB MIN-D plug (mate supplied) and output is via an SHV
style coaxial connector (mate supplied).
ORDERING INFORMATION:
Please note when ordering a CM3 the C Series is not included and must
be ordered separately.
PROGRAMMING INSTRUCTIONS
• Onboard Potentiometer: connect pins 7 to 4 and 8 to 3, turn
potentiometer to adjust high voltage.
OR
• Remote Potentiometer: connect wiper arm to pin 3, other sides
to pins 4 and 2.
OR
• Remote Analog Signal: apply programming voltage to pin 3,
return to pin 2.
WWW.XPPOWER.COM
4711CR
PAGE 10