X76F100 Datasheet, PDF (8/17 Pages) Xicor Inc. – 1K 128 x 8 Bit

X76F100
ABSOLUTE MAXIMUM RATINGS
Temperature under bias ....................–65°C to +135°C
Storage temperature ........................–65°C to +150°C
Voltage on any pin with
respect to V_SS......................................... –1V to +7V
D.C. output current ............................................... 5mA
Lead temperature (soldering, 10 seconds).........300°C
RECOMMENDED OPERATING CONDITIONS
Temperature
Commercial
Industrial
Min.
0°C
–40°C
Max.
+70°C
+85°C
COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only; functional operation of the
device (at these or any other conditions above those
listed in the operational sections of this specification) is
not implied. Exposure to absolute maximum rating con-
ditions for extended periods may affect device reliability.
Supply Voltage
X76F100
X76F100-3
Limits
4.5V to 5.5V
3.0V to 5.5V
D.C. OPERATING CHARACTERISTICS (Over the recommended operating conditions unless otherwise specified.)
Symbol
I_CC1
I_CC2⁽³⁾
I_SB1⁽¹⁾
I_SB2⁽¹⁾
I_LI
I_LO
V_IL⁽²⁾
V_IH⁽²⁾
V_OL
Parameter
V_CC Supply Current
(Read)
V_CC Supply Current
(Write)
V_CC Supply Current
(Standby)
V_CC Supply Current
(Standby)
Input Leakage Current
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
Output LOW Voltage
Limits
Min.
Max. Unit
1
mA
3
mA
1
µA
1
µA
10
µA
10
µA
–0.5 V_CC x 0.3 V
V_CC x 0.7 V_CC + 0.5 V
0.4
V
Test Conditions
f_SCL = V_CC x 0.1/V_CC x 0.9 Levels @ 400 kHz,
SDA = Open
RST = CS = V_SS
f_SCL = V_CC x 0.1/V_CC x 0.9 Levels @ 400 kHz,
SDA = Open
RST = CS = V_SS
V_IL = V_CC x 0.1, V_IH = V_CC x 0.9
f_SCL = 400 kHz, f_SDA = 400 kHz
V_SDA = V_SCC = V_CC
Other = GND or V_CC–0.3V
V_IN = V_SS to V_CC
V_OUT = V_SS to V_CC
I_OL = 3mA
CAPACITANCE T_A = +25°C, f = 1MHz, V_CC = 5V
Symbol
C_OUT⁽³⁾
C_IN⁽³⁾
Test
Output Capacitance (SDA)
Input Capacitance (RST, SCL, CS)
Max.
8
6
Unit
pF
pF
Conditions
V_I/O = 0V
V_IN = 0V
Notes: (1) Must perform a stop command after a read command prior to measurement.
(2) V_IL min. and V_IH max. are for reference only and are not tested.
(3) This parameter is periodically sampled and not 100% tested.
REV 1.0 6/22/00
www.xicor.com
Characteristics subject to change without notice. 8 of 16