X28HC64 Datasheet, PDF (10/24 Pages) Xicor Inc. – 5 Volt, Byte Alterable E2PROM

X28HC64
ABSOLUTE MAXIMUM RATINGS*
Temperature under Bias
X28HC64 ..................................... –10°C to +85°C
X28HC64I, X28HC64M ............. –65°C to +135°C
Storage Temperature ....................... –65°C to +150°C
Voltage on any Pin with
Respect to V_SS ....................................... –1V to +7V
D.C. Output Current ............................................. 5mA
Lead Temperature
(Soldering, 10 seconds) .............................. 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation of
the device at these or any other conditions above those
indicated in the operational sections of this specification is
not implied. Exposure to absolute maximum rating condi-
tions for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Min.
Max.
Commercial
Industrial
Military
0°C
–40°C
–55°C
+70°C
+85°C
+125°C
3857 PGM T02.1
Supply Voltage
X28HC64
Limits
5V ±10%
3857 PGM T03.1
D.C. OPERATING CHARACTERISTICS (Over recommended operating conditions unless otherwise specified.)
Symbol
Parameter
I_CC
V_CC Current (Active)
(TTL Inputs)
I_SB1 V_CC Current (Standby)
(TTL Inputs)
I_SB2 V_CC Current (Standby)
(CMOS Inputs)
I_LI
I_LO
V_lL(2)
V_IH(2)
V_OL
V_OH
Input Leakage Current
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
Output LOW Voltage
Output HIGH Voltage
Min.
–1
2
2.4
Limits
Typ.⁽¹⁾
15
Max.
40
Units
mA
1
2
mA
100
200
µA
±10
µA
±10
µA
0.8
V
V_CC + 1 V
0.4
V
V
Test Conditions
CE = OE = V_IL, WE = V_IH, All
I/O’s = Open, Address Inputs =
TTL Levels @ f = 10 MHz
CE = V_IH, OE = V_IL
All I/O’s = Open, Other Inputs = V_IH
CE = V_CC – 0.3V, OE = GND
All I/O’s = Open, Other Inputs =
V_CC – 0.3V
V_IN = V_SS to V_CC
V_OUT = V_SS to V_CC, CE = V_IH
I_OL = 5mA
I_OH = –5mA
3857 PGM T04.2
Notes: (1) Typical values are for T_A = 25°C and nominal supply voltage
(2) V_IL min. and V_IH max. are for reference only and are not tested.
10