WM8940_07 Datasheet, PDF (55/85 Pages) Wolfson Microelectronics plc – Mono CODEC with Speaker Driver

Pre-Production
WM8940
Figure 30 PLL and Clock Select Circuit
The PLL frequency ratio R = f2/f1 (see Figure 30) can be set using the register bits PLLK and PLLN.
N controls the ratio of the division, and K the fractional part.
The nominal output frequency of the PLL (PLL_OUT) is 98.304MHz.
The PLL output then passes through a fixed divide by 4, and can also be further divided by
MCLKDIV[3:0] (see figure 34). The divided clock (SYSCLK) can be used to clock the WM8940
DSP.
REGISTER
ADDRESS
R36
PLL N value
BIT
LABEL
7 PLL_POWERDOWN
6 FRACEN
5:4 PLLPRESCALE
3:0 PLLN
R37
5:0 PLLK [23:18]
PLL K value 1
R38
8:0 PLLK [17:9]
PLL K Value 2
R39
8:0 PLLK [8:0]
PLL K Value 3
Table 47 PLL Frequency Ratio Control
DEFAULT
0
1
00
1100
0Ch
093h
0E9h
DESCRIPTION
PLL POWER
0=ON
1=OFF
Fractional Divide within the PLL
0=Disabled (Lower Power)
1=Enabled
00 = MCLK input multiplied by 2
(default)
01 = MCLK input not divided (default)
10 = Divide MCLK by 2 before input to
PLL
11 = Divide MCLK by 4 before input to
PLL
Integer (N) part of PLL input/output
frequency ratio. Use values greater
than 5 and less than 13.
Fractional (K) part of PLL1
input/output frequency ratio (treat as
one 24-digit binary number).
w
Pre-Production, Rev 3.0, February 2007
55