W19B320BT Datasheet, PDF (9/56 Pages) Winbond – 2.7~3.6-volt write (program and erase) operations

W19B320BT/B DATASHEET
6. FUNCTIONAL DESCRIPTION
6.1 Device Bus Operation
6.1.1 Word/Byte Configuration
The #BYTE pin controls the device data I/O pins operate whether in the byte or word configuration.
When the #BYTE pin is ‘1’, the device is in word configuration; DQ0 -DQ15 are active and controlled
by #CE and #OE.
When the #BYTE pin is ‘0’, the device is in byte configuration, and only data I/O pins DQ0-DQ7 are active
and controlled by #CE and #OE. The data I/O pins DQ8-DQ14 are tri-stated, and the DQ15 pin is
used as an input for the LSB (A-1) address function.
6.1.2 Reading Array Data
To read array data from the outputs, the #CE and #OE pins must be set to V_IL. #CE is the power
control and used to select the device. #OE is the output control and gates array data to the output
pins. #WE should stay at V_IH. The #BYTE pin determines the device outputs array data whether in
words or bytes.
The internal state machine is set for reading array data when device power-up, or after hardware
reset. This ensures that no excess modification of the memory content occurs during the power
transition. In this mode there is no command necessary to obtain array data. Standard microprocessor
read cycles that assert valid addresses on the device address inputs produce valid data on the device
data outputs. Each bank remains enabled for read access until the command register contents are
changed.
6.1.3 Writing Commands/Command Sequences
In writhing a command or command sequence (which includes programming data to the device and
erasing sectors of memory), the system must drive #WE and #CE to V_IL, and #OE to V_IH.
For program operations, the #BYTE pin determines the device accepts program data whether in bytes
or in words. Refer to “Word/Byte Configuration” for more information.
The Unlock Bypass mode of device is to facilitate a faster programming. When a bank enters the
Unlock Bypass mode, only two write cycles are required to program a word or byte. Please refer to
"Word/Byte Configuration” section for details on programming data to the device using both standard
and Unlock Bypass command sequences.
The erase operation can erase a sector, multiple sectors, even the entire device. The “sector address”
is the address bits required to solely select a sector.
Accelerated Program Operation
The device provides accelerated program operations through the ACC function. This is one of two
functions provided by the #WP/ACC pin. This function is primarily intended to allow a faster
manufacturing throughput in the factory.
If #WP/ACC pin is set at V_HH, the device automatically enters into the Unlock Bypass mode. Then the
device will temporarily unprotect any protected sectors, and uses the higher voltage on this pin to
reduce the time required for program operations. The system would use a two-cycle program
command sequence required by the Unlock Bypass mode. When V_HH is removed from the #WP/ACC
pin, the device is back to a normal operation.
Publication Release Date: Dec. 25, 2007
-9-
Revision A3