|
W83637HF_06 Datasheet, PDF (8/151 Pages) Winbond – LPC I/O | |||
|
◁ |
W83637HF/HG
2. FEATURES
General
⢠Meet LPC Spec. 1.01
⢠Support LDRQ#(LPC DMA), SERIRQ (serial IRQ)
⢠Compliant with Microsoft PC2000/PC2001 Hardware Design Guide
⢠Support DPM (Device Power Management), ACPI
⢠Programmable configuration settings
⢠Single 24 or 48 MHz clock input
FDC
â¢
â¢
â¢
â¢
â¢
â¢
â¢
â¢
â¢
Compatible with IBM PC AT disk drive systems
Variable write pre-compensation with track selectable capability
Support vertical recording format
DMA enable logic
16-byte data FIFOs
Support floppy disk drives and tape drives
Detects all overrun and underrun conditions
Built-in address mark detection circuit to simplify the read electronics
FDD anti-virus functions with software write protect and FDD write enable signal (write data
signal was forced to be inactive)
⢠Support up to four 3.5-inch or 5.25-inch floppy disk drives
⢠Completely compatible with industry standard 82077
⢠360K/720K/1.2M/1.44M/2.88M format; 250K, 300K, 500K, 1M, 2M bps data transfer rate
⢠Support 3-mode FDD, and its Win95/98 driver
UART
⢠Two high-speed 16550 compatible UARTs with 16-byte send/receive FIFOs
⢠MIDI compatible
⢠Fully programmable serial-interface characteristics:
--- 5, 6, 7 or 8-bit characters
--- Even, odd or no parity bit generation/detection
--- 1, 1.5 or 2 stop bits generation
⢠Internal diagnostic capabilities:
--- Loop-back controls for communications link fault isolation
--- Break, parity, overrun, framing error simulation
⢠Programmable baud generator allows division of 1.8461 MHz and 24 MHz by 1 to (216-1)
⢠Maximum baud rate up to 921k bps for 14.769 MHz and 1.5M bps for 24 MHz
Publication Release Date: March, 2006
-3-
Revision 1.6
|
▷ |