W25Q128FVSIF-TR Datasheet, PDF (50/100 Pages) Winbond – 3V 128M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI

W25Q128FV
8.2.14Set Burst with Wrap (77h)
In Standard SPI mode, the Set Burst with Wrap (77h) instruction is used in conjunction with “Fast Read
Quad I/O” and “Word Read Quad I/O” instructions to access a fixed length of 8/16/32/64-byte section
within a 256-byte page. Certain applications can benefit from this feature and improve the overall
system code execution performance.
Similar to a Quad I/O instruction, the Set Burst with Wrap instruction is initiated by driving the /CS pin
low and then shifting the instruction code “77h” followed by 24 dummy bits and 8 “Wrap Bits”, W7-0.
The instruction sequence is shown in Figure 28. Wrap bit W7 and the lower nibble W3-0 are not used.
W6, W5
00
01
10
11
W4 = 0
Wrap Around
Wrap Length
Yes
8-byte
Yes
16-byte
Yes
32-byte
Yes
64-byte
W4 =1 (DEFAULT)
Wrap
Around
Wrap
Length
No
N/A
No
N/A
No
N/A
No
N/A
Once W6-4 is set by a Set Burst with Wrap instruction, all the following “Fast Read Quad I/O” and
“Word Read Quad I/O” instructions will use the W6-4 setting to access the 8/16/32/64-byte section
within any page. To exit the “Wrap Around” function and return to normal read operation, another Set
Burst with Wrap instruction should be issued to set W4 = 1. The default value of W4 upon power on or
after a software/hardware reset is 1.
In QPI mode, the “Burst Read with Wrap (0Ch)” instruction should be used to perform the Read
operation with “Wrap Around” feature. The Wrap Length set by W5-4 in Standard SPI mode is still valid
in QPI mode and can also be re-configured by “Set Read Parameters (C0h)” instruction. Refer to
8.2.44 and 8.2.45 for details.
/CS
CLK
Mode 3
Mode 0
IO₀
IO₁
IO₂
IO₃
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Mode 3
Instruction (77h)
don't
care
don't
care
don't
care
Wrap Bit
Mode 0
X X X X X X w4 X
X X X X X X w5 X
X X X X X X w6 X
XXXXXXXX
Figure 28. Set Burst with Wrap Instruction (SPI Mode only)
- 49 -