W25P16VSFIG-TR Datasheet, PDF (15/43 Pages) Winbond – 8M-BIT, 16M-BIT AND 32M-BIT SERIAL FLASH MEMORY

W25P80 / W25P16 / W25P32
Write Disable (04h)
The Write Enable instruction (Figure 4) sets the Write Enable Latch (WEL) bit in the Status Register to
a 1. The WEL bit must be set prior to every Page Program, Sector Erase, Chip Erase and Write Status
Register instruction. The Write Enable instruction is entered by driving /CS low, shifting the instruction
code “06h” into the Data Input (DI) pin on the rising edge of CLK, and then driving /CS high.
Figure 4. Write Disable Instruction Sequence Diagram
9.2.3 Write Enable (06h)
The Write Disable instruction (Figure 5) resets the Write Enable Latch (WEL) bit in the Status Register
to a 0. The Write Disable instruction is entered by driving /CS low, shifting the instruction code “04h”
into the DI pin and then driving /CS high. Note that the WEL bit is automatically reset after Power-up
and upon completion of the Write Status Register, Page Program, Sector Erase, and Chip Erase
instructions.
Figure 5. Write Enable Instruction Sequence Diagram
Publication Release Date: December 11, 2005
- 15 -
Revision J