W3E232M16S-XSTX Datasheet, PDF (20/22 Pages) White Electronic Designs Corporation – 2x32Mx16bit DDR SDRAM

White Electronic Designs
49. CKE must be active (high) during the entire time a refresh command is executed.
That is, from the time the AUTO REFRESH command is registered, CKE must be
active at each rising clock edge, until tRFC has been satisfied.
50. ICC2N specifies the DQ, DQS, and DQM to be driven to a valid high or low logic
level. ICC2Q is similar to ICC2F except ICC2Q specifies the address and control inputs
to remain stable. Although ICC2F, ICC2N, and ICC2Q are similar, ICC2F is “worst case.”
51. Whenever the operating frequency is altered, not including jitter, the DLL is
required to be reset followed by 200 clock cycles before any READ command.
52. This is the DC voltage supplied at the DRAM and is inclusive of all noise up to 20
MHz. Any noise above 20 MHz at the DRAM generated from any source other than
that of the DRAM itself may not exceed the DC coltage range of 2.6V ± 100mV.
53. One TSOP current mode, one TSOP in precharge power down standby mode
(IDD2P).
54. Both TSOPs in same current mode.
W3E232M16S-XSTX
PRELIMINARY*
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
December 2005
Rev. 1
20
White Electronic Designs Corporation • [phone] • www.wedc.com