PI3303-00-EVAL1 Datasheet, PDF (9/42 Pages) Vicor Corporation – Cool-Power® ZVS Switching Regulators

PI3318-x0-LGIZ (1.8V_OUT) Electrical Characteristics
Unless otherwise specified: -40°C < T_J < 125°C, V_IN = 24V, L1 = 155nH ^[1]
Parameter
Symbol
Conditions
PI33xx-x0
Min
Typ
Max
Unit
Input Voltage
Input Current
Input Current At Output Short (fault
condition duty cycle)
Input Quiescent Current
Input Voltage Slew Rate
V_{IN_DC}
I_{IN_DC}
I_{IN_Short}
I_{Q_VIN}
V_{IN_SR}
Input Specifications
V_IN = 24V, T_C = 25°C, I_OUT =10A
[2]
Disabled
Enabled (no load)
8
24
36
V
835
mA
20
mA
2.0
mA
2.5
mA
1
V/μs
Output Voltage Total Regulation
Output Voltage Trim Range
Line Regulation
Load Regulation
Output Voltage Ripple
Continuous Output
Current Range
Current Limit
Output Specifications
V_{OUT_DC}
[2]
V_{OUT_DC}
[3]
∆V_OUT (∆V_IN) @25°C, 8V < V_IN < 36V
∆V_OUT (∆I_OUT)
V_{OUT_AC}
@25°C, 0.5A < I_OUT < 10A
I_OUT = 5A, C_OUT = 6 x 100μF, 20MHz BW ^[4]
I_{OUT_DC}
[5] _{Minimum 1mA load required}
I_{OUT_CL}
1.773
1.8
1.827
V
1.4
2.0
V
0.10
%
0.10
%
25
mVp-p
0.001
10
A
12
A
Protection
V_IN UVLO Start Threshold
V_{UVLO_START}
7.10
7.60
8.00
V
V_IN UVLO Stop Threshold
V_{UVLO_STOP}
6.80
7.25
7.60
V
V_IN UVLO Hysteresis
V_{UVLO_HYS}
0.33
V
V_IN OVLO Start Threshold
V_{OVLO_START}
37.0
38.4
V
V_IN OVLO Stop Threshold
V_{OVLO_STOP}
36.1
V
V_IN OVLO Hysteresis
V_{OVLO_HYS}
0.77
V
V_IN UVLO/OVLO Fault Delay Time
t_{f_DLY}
Number of the switching freq cycles
128
Cycles
V_IN UVLO/OVLO Response Time
t_f
500
ns
Output Overvoltage Protection
V_OVP
Above V_OUT
20
%
Overtemperature
Fault Threshold
T_OTP
130
135
140
°C
Overtemperature
Restart Hysteresis
T_{OTP_HYS}
30
°C
[1] _{All parameters reflect regulator and inductor system performance. Measurements were made using a standard PI33xx-x0 evaluation board with 3x4”}
dimensions and 4 layer, 2oz copper. Refer to inductor pairing table within Application Description section for specific inductor manufacturer and value.
[2] _{Regulator is assured to meet performance specifications by design, test correlation, characterization, and/or statistical process control.}
[3] _{Output current capability may be limited and other performance may vary from electrical characteristics when switching frequency or VOUT is modified.}
[4] _{Refer to Output Ripple plots.}
[5] _{Refer to Load Current vs. Ambient Temperature curves.}
[6] _{Refer to Switching Frequency vs. Load current curves.}
Cool-Power^® ZVS Switching Regulators
Page 9 of 42
Rev 2.4
02/2017
vicorpower.com
800 927.9474