TCD6000 Datasheet, PDF (30/36 Pages) Tripath Technology Inc. – 6 CHANNEL CLASS-T DIGITAL AUDIO PROCESSOR USING DIGITAL POWER PROCESSINGTM TECHNOLOGY

I2C Programming Examples
Tripath Technology, Inc. – Preliminary Technical Information
Initialization string for a Tripath TP2150B with PGC off:
sub-address value
20h
00000000b Un-freeze registers. System starts in mute so the instruction sequence is not
important.
21h
11000000b Turn off de-emphasis and DC blocking filters. Turn on droop correction filter.
22h
00010000b 48kHz sampling rate.
23h
01000011b MCK will be 48kHz * 256 = 12.288MHz. Sync Reset is on and it will trigger a
hard-mute.
24h
00011011b Standard I2S format.
25h
00h
Channel 1 Volume
26h
00h
Channel 2 Volume
27h
00h
Channel 3 Volume
28h
00h
Channel 4 Volume
29h
00h
Channel HP1 Volume
2Ah
00h
Channel HP2 Volume
2Bh
00h
Leave Volume Ramp Rate at 00h while not changing volume.
2Ch
00000010b Start out in hard-mute. Turn off Auto-Mute.
2Dh
00h
Auto-Mute Timing
2Eh
00000011b Coarse Gain = 1x. Volume Ramp Enable and Zero Crossing Enable
2Fh
01100000b Bypass DC calibration for headphone outputs.
30h
00h
CalibBank0Ex
31h
00h
CalibBank1Ex
32h
00h
CalibBank2Ex
33h
00h
CalibBank012Ex
34h
00h
CalibBank3Ex
35h
00h
CalibBank4Ex
36h
00h
CalibBank5Ex
37h
00h
CalibBank345Ex
38h
00h
Clear Force DC register.
39h
3Ch
Set Dither Control to 3Ch.
3Ah
00000100b Enable Fault Latch.
3Bh
FFh
Always set Saturation Clamp to these values.
3Ch
E7h
Always set Saturation Clamp to these values.
3Dh
00000000b Turn on PGC.
73h
00001011b Use 195nS delay to slow down switching (adjust as needed for each design).
74h
00000000b HMUTE is active high, HPO = 0, TST_EN output is low.
75h
00h
Test.
76h
10001011b Enable Delay compensation. Use A-cal for single ended output. Enable
startup burst for bootstrap. BBM = 45nS (adjust as needed for each design).
77h
00000000b Individual channel hard mutes are inactive.
78h
10000000b Channel 1 high post-gain.
79h
00h
Test.
7Ah
10000000b Channel 2 high post-gain.
7Bh
11110000b Channel 3, 4, 5, and 6 high post-gain.
7Ch
00h
Test.
7Dh
00000000b All channels use A-cal for single ended output.
To Un-mute a TP2150B:
sub-address value
2Ch
00000000b Remove Hard-Mute to begin automatic DC calibration.
<If PGC is on, wait 4 seconds for automatic DC calibration. If PGC is off, wait 1 second for calibration.>
30
TCD6000 – Rev. 1.0/09.04