THNCF008MAA Datasheet, PDF (34/52 Pages) Toshiba Semiconductor – CompactFlash Card

Preliminary version
THNCFxxxMAA Series
Identify Drive Information
Word address Default value Total bytes Data field type information
0
848AH
2
General configuration bit-significant information
1
XXXX
2
Default number of cylinders
2
0000H
2
Reserved
3
00XXH
2
Default number of heads
4
0000H
2
Number of unformatted bytes per track
5
XXXX
2
Number of unformatted bytes per sector
6
XXXX
2
Default number of sectors per track
7 to 8
XXXX
4
Number of sectors per card(Word7=MSW,Words=LSW)
9
0000H
2
Reserved
10 to 19
XXXX
20
Serial number in ASCII
20
0001H
2
Buffer type(single ported)
21
0004H
2
Buffer size in 512 byte increments
22
0004H
2
# of ECC bytes passed on Read/Write Long Commands
23 to 46
XXXX
48
Firmware revision in ASCII etc.
47
0001H
2
Maximum of 1 sector on Read/Write Multiple command
48
0000H
2
Double Word not supported
49
0200H
2
Capabilities: DMA NOT Supported(bit 8), LBA supported
(bi 9)
50
0000H
2
Reserved
51
0200H
2
PIO data transfer cycle timing mode 2
52
0000H
2
DMA data transfer cycle timing mode not Supported
53 to 58
XXXX
12
Reserved
59
0101H
2
Multiple sector setting is valid
60 to 61
XXXX
4
Total number of sectors addressable in LBA Mode
62 to 255
0000H
388
Reserved
6.Idle (code: E3H or 97H): This command causes the Card to set BSY, enter the Idle mode, clear BSY and generate
an interrupt. If sector count is non-zero, the automatic power down mode is enabled. If the sector count is
zero, the automatic power mode is disabled.
7.Idle Immediate (code: E1H or 95H): This command causes the Card to set BSY, enter the Idle(Read) mode, clear
BSY and generate an interrupt.
8.Initialize Drive Parameters (code: 91H): This command enables the host to set the number of sectors per track
and the number of heads per cylinder.
9.Read Buffer (code: E4H): This command enables the host to read the current contents of the card’s sector
buffer.
2001-09-05 34/52