CC430F613 Datasheet, PDF (84/120 Pages) Texas Instruments – MSP430 SoC with RF Core

CC430F613x
CC430F612x
CC430F513x
ECCN 5E002 TSPA - Technology / Software Publicly Available
SLAS554E – MAY 2009 – REVISED NOVEMBER 2010
www.ti.com
Frequency Synthesizer Characteristics
T_A = 25°C, V_CC = 3 V (unless otherwise noted)⁽¹⁾
MIN figures are given using a 27MHz crystal. TYP and MAX figures are given using a 26MHz crystal.
PARAMETER
Programmed frequency resolution⁽²⁾
Synthesizer frequency tolerance⁽³⁾
TEST CONDITIONS
26- to 27-MHz crystal
MIN
397
TYP
f_XOSC/2¹⁶
±40
50-kHz offset from carrier
–95
100-kHz offset from carrier
–94
200-kHz offset from carrier
–94
RF carrier phase noise
500-kHz offset from carrier
1-MHz offset from carrier
–98
–107
2-MHz offset from carrier
–112
5-MHz offset from carrier
–118
PLL turn-on / hop time⁽⁴⁾
PLL RX/TX settling time⁽⁵⁾
PLL TX/RX settling time⁽⁶⁾
PLL calibration time⁽⁷⁾
10-MHz offset from carrier
Crystal oscillator running
–129
85.1
88.4
9.3
9.6
20.7
21.5
694
721
MAX
412
88.4
9.6
21.5
721
UNIT
Hz
ppm
dBc/Hz
µs
µs
µs
µs
(1) All measurement results are obtained using the EM430F6137RF900 with BOM according to tested frequency range (see Table 46).
(2) The resolution (in Hz) is equal for all frequency bands.
(3) Depends on crystal used. Required accuracy (including temperature and aging) depends on frequency band and channel bandwidth /
spacing.
(4) Time from leaving the IDLE state until arriving in the RX, FSTXON, or TX state, when not performing calibration.
(5) Settling time for the 1-IF frequency step from RX to TX
(6) Settling time for the 1-IF frequency step from TX to RX
(7) Calibration can be initiated manually or automatically before entering or after leaving RX/TX.
84
Submit Documentation Feedback
Copyright © 2009–2010, Texas Instruments Incorporated