THS6042_16 Datasheet, PDF (5/46 Pages) Texas Instruments – 350mA,12V ADSL CPE LINE DRIVERS

THS6042, THS6043
350 mA, ±12 V ADSL CPE LINE DRIVERS
SLOS264G − MARCH 2000 − REVISED DECEMBER 2001
electrical characteristics over recommended operating free-air temperature range, T_A = 25°C,
V_CC = ±12 V, R_(FEEDBACK) = 750 Ω, R_L = 100 Ω (unless otherwise noted) (continued)
power supply
PARAMETER
VCC
Operating range
Dual supply
Single supply
ICC
Quiescent current (each driver)
PSRR
Power supply rejection ratio
TEST CONDITIONS
VCC = ±12 V
VCC = ±6 V
VCC = ±12 V
VCC = ±6 V
TA = 25°C
TA = full range
TA = 25°C
TA = full range
TA = 25°C
TA = full range
TA = 25°C
TA = full range
MIN
± 4.5
9
−65
−62
−62
−60
TYP MAX
± 16.5
33
8.2 10.5
11.5
7.4 9.5
10.5
− 72
UNIT
V
mA
dB
− 69
shutdown characteristics (THS6043 only)
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNIT
VIL(SHDN) Shutdown pin voltage for power up
VCC = ±6 V, ±12 V, GND = 0 V
(GND Pin as Reference)
0.8 V
VIH(SHDN) Shutdown pin voltage for power down
VCC = ±6 V, ±12 V, GND = 0 V
(GND pin as reference)
2
V
ICC(SHDN) Total quiescent current when in shutdown state VCC = ±6 V, ±12 V
0.3 0.7 mA
tDIS
Disable time (see Note 3)
VCC = ±12 V
0.5
µs
tEN
Enable time (see Note 3)
VCC = ±12 V
0.2
µs
IIL(SHDN) Shutdown pin input bias current for power up
VCC = ±6 V, ±12 V
40 100 µA
IIH(SHDN) Shutdown pin input bias current for power down VCC = ±6 V, ±12 V V(SHDN) = 3.3 V
50 100 µA
NOTE 3: Disable/enable time is defined as the time from when the shutdown signal is applied to the SHDN pin to when the supply current has
reached half of its final value.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
5