English
Language : 

BQ24707 Datasheet, PDF (5/36 Pages) Texas Instruments – 1-4 Cell Li+ Battery SMBus Charge Controller With Independent Comparator and Advanced Circuit Protection
www.ti.com
bq24707
bq24707A
SLUSA78B – JULY 2010 – REVISED MARCH 2011
ELECTRICAL CHARACTERISTICS (continued)
4.5 V ≤ V(VCC) ≤ 24 V, 0°C ≤ TJ ≤ 125°C, typical values are at TA = 25°C, with respect to GND (unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
INPUT UNDERVOLTAGE LOCK-OUT COMPARATOR (UVLO)
VUVLO
Input under voltage rising threshold
VUVLO_HYS
Input under voltage falling hysteresis
FAST DPM COMPARATOR (FAST_DPM)
VVCC rising
VVCC falling
3.5
3.75
4
340
VFAST_DPM
Fast DPM comparator stop charging rising threshold
with respect to input current limit, voltage across input
sense resistor rising edge (specified by design)
108%
QUIESCENT CURRENT
IBAT
Total battery leakage current to ISRN + ISRP +IPHASE +
IVCC + IACP + IACN
ISTANDBY
Standby quiescent current, IVCC + IACP + IACN
IAC_NOSW
Adapter bias current during charge,
IVCC + IACP + IACN
IAC_SW
Adapter bias current during charge,
IVCC + IACP + IACN
ACOK COMPARATOR
VVCC < VBAT = 16.8V, TJ = 0 to 85°C
VVCC > VUVLO, VACDET > 0.6V, charge disabled,
TJ = 0 to 85°C
VVCC > VUVLO, VACDET > 2.4V,
charge enabled, no switching, TJ = 0 to 85°C
VVCC > VUVLO, VACDET > 2.4V,
charge enabled, switching, MOSFET Sis412DN
15
0.5
1
1.5
3
10
VACOK_FALL
VACOK_RISE_HYS
ACOK falling threshold
ACOK rising hysteresis
VVCC>VUVLO, VACDET rising
VVCC>VUVLO, VACDET falling
VVCC>VUVLO, VACDET rising above 2.4V,
ChargeOption() bit [15] = 0 (default), (bq24707 only)
2.376
35
0.9
2.4 2.424
55
75
1.3
1.7
tACOK_FALL_DEG
ACOK falling deglitch (specified by design)
VVCC>VUVLO, VACDET rising above 2.4V,
ChargeOption() bit [15] = 0 (default), (bq24707A only)
0.8
1.2
2
VVCC>VUVLO, VACDET rising above 2.4V,
ChargeOption() bit [15] = 1
10
50
VWAKEUP_RISE
WAKEUP detect rising threshold
VWAKEUP_FALL
WAKEUP detect falling threshold
VCC to SRN COMPARATOR (VCC_SRN)
VVCC>VUVLO, VACDET rising
VVCC>VUVLO, VACDET falling
0.57
0.8
0.3
0.51
VVCC-SRN_FALL
VCC-SRN falling threshold
VVCC-SRN _RHYS
VCC-SRN rising hysteresis
HIGH SIDE IFAULT COMPARATOR (IFAULT_HI)(1)
VVCC falling towards VSRN
VVCC rising above VSRN
70
125
180
70
120
170
ChargeOption() bit [8:7] = 00
200
300
450
VIFAULT_HI_RISE
ACP to PHASE rising threshold
ChargeOption() bit [8:7] = 01
ChargeOption() bit [8:7] = 10 (default)
330
500
700
450
700
1000
ChargeOption() bit [8:7] = 11
600
900
1250
LOW SIDE IFAULT COMPARATOR (IFAULT_LOW)
VIFAULT_LOW_RISE
PHASE to GND rising threshold
INPUT OVER-CURRENT COMPARATOR (ACOC)(1)
40
110
160
VACOC
Adapter over current rising threshold with respect to
input current limit, voltage across input sense resistor
rising edge
ChargeOption() bit [2:1] = 01
ChargeOption() bit [2:1] = 10 (default)
ChargeOption() bit [2:1] = 11
120%
150%
200%
133%
166%
222%
145%
180%
240%
VACOC_min
Min ACOC threshold clamp voltage
ChargeOption() bit [2:1] = 01 (133%),
InputCurrent() = 0x0400H (10.24mV)
40
45
50
VACOC_max
Max ACOC threshold clamp voltage
ChargeOption() bit [2:1] = 11 (222%),
InputCurrent() = 0x1F80H (80.64mV)
140
150
160
tACOC_DEG
ACOC deglitch time (specified by design)
BAT OVER-VOLTAGE COMPARATOR (BAT_OVP)
Voltage across input sense resistor rising to disable charge
1.7
2.5
3.3
VOVP_RISE
Over voltage rising threshold as percentage of
VBAT_REG
VOVP_FALL
Over voltage falling threshold as percentage of
VBAT_REG
CHARGE OVERCURRENT COMPARATOR (CHG_OCP)
VSRN rising
VSRN falling
103%
104%
102%
106%
VOCP_RISE
Charge over current rising threshold, measure voltage
drop across current sensing resistor
ChargeCurrent() = 0x0xxxH
ChargeCurrent() = 0x1000H – 0x17C0H
ChargeCurrent() = 0x1800 H– 0x1FC0H
54
60
66
80
90
100
110
120
130
UNIT
V
mV
µA
mA
mA
mA
V
mV
s
ms
μs
V
V
mV
mV
mV
mV
mV
mV
ms
mV
mV
mV
(1) User can adjust threshold via SMBus ChargeOption() REG0x12.
© 2010–2011, Texas Instruments Incorporated
Submit Documentation Feedback
5
Product Folder Link(s): bq24707 bq24707A