THS4532_16 Datasheet, PDF (48/58 Pages) Texas Instruments – Ultra Low Power, Rail-to-Rail Output, Fully-Differential Amplifier

THS4532
SLOS829A – FEBRUARY 2013 – REVISED JULY 2015
11 Layout
www.ti.com
11.1 Layout Guidelines
The THS4532 EVM (SLOU356) should be used as a reference when designing the circuit board. TI recommends
following the EVM layout of the external components near to the amplifier, ground plane construction, and power
routing as closely as possible. General guidelines are:
1. Signal routing should be direct and as short as possible into and out of the amplifier.
2. The feedback path should be short and direct avoiding vias if possible.
3. Ground or power planes should be removed from directly under the amplifier’s input and output pins.
4. A series output resistor is recommended to be placed as near to the output pin as possible. See Figure 79
for recommended values given expected capacitive load of design.
5. A 2.2-µF power supply decoupling capacitor should be placed within 2 inches of the device and can be
shared with other amplifiers. For split supply, a capacitor is required for both supplies.
6. A 0.1-µF power supply decoupling capacitor should be placed as near to the power supply pins as possible.
Preferably within 0.1 inch. For split supply, a capacitor is required for both supplies.
7. The PD pin uses TTL logic levels referenced to the negative supply voltage (V_S-). When not used it should
tied to the positive supply to enable the amplifier. When used, it must be actively driven high or low and
should not be left in an indeterminate logic state. A bypass capacitor is not required, but can be used for
robustness in noisy environments.
48
Submit Documentation Feedback
Product Folder Links: THS4532
Copyright © 2013–2015, Texas Instruments Incorporated