SN74AVCH16T245_15 Datasheet, PDF (3/30 Pages) Texas Instruments – 16-Bit Dual-Supply Bus Transceiver

www.ti.com
SN74AVCH16T245
SCES587D – AUGUST 2004 – REVISED NOVEMBER 2015
5 Description (continued)
The SN74AVCH16T245 control pins (1DIR, 2DIR, 1OE, and 2OE) are supplied by V_CCA.
The I_off circuitry disables the outputs, preventing damaging current backflow through the device when it is
powered down. This device is fully specified for partial-power-down applications using I_off.
The V_CC isolation feature ensures that if either V_CC input is at GND, then both ports are in the high-impedance
state.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors
with the bus-hold circuitry is not recommended.
To ensure the high-impedance state during power up or power down, OE should be tied to V_CC through a pullup
resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The SN74AVCH16T245 is designed for asynchronous communication between data buses. The device transmits
data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-
control (DIR) input. The output-enable (OE) input can be used to disable the outputs so the buses are effectively
isolated.
Copyright © 2004–2015, Texas Instruments Incorporated
Product Folder Links: SN74AVCH16T245
Submit Documentation Feedback
3