DRV8823_16 Datasheet, PDF (22/32 Pages) Texas Instruments – 4-Bridge Serial Interface Motor Driver

DRV8823
SLVS913E – JANUARY 2009 – REVISED JANUARY 2016
www.ti.com
10.3 Thermal Considerations
The DRV8823 has TSD as described in Thermal Shutdown (TSD). If the die temperature exceeds approximately
150°C, the device is disabled until the temperature drops to a safe level.
Any tendency of the device to enter TSD is an indication of excessive power dissipation, insufficient heatsinking,
or too high an ambient temperature.
10.3.1 Power Dissipation
Power dissipation in the DRV8823 is dominated by the power dissipated in the output FET resistance, or R_DS(ON).
Average power dissipation when running a stepper motor can be roughly estimated by Equation 3.
P = 4 R (I )²
TOT
· _DS(ON) · _OUT(RMS)
where
• P_TOT is the total power dissipation.
• R_DS(ON) is the resistance of each FET.
• I_OUT(RMS) is the RMS output current being applied to each winding.
(3)
I_OUT(RMS) is equal to approximately 0.7x the full-scale output current setting. The factor of 4 comes from the fact
that there are two motor windings, and at any instant two FETs are conducting winding current for each winding
(one high side and one low side). Remember that the DRV8823 has two stepper motor drivers, so the power
dissipation of each must be added together to determine the total device power dissipation.
The maximum amount of power that can be dissipated in the DRV8823 depends on ambient temperature and
heatsinking. Use the thermal Dissipation Ratings to estimate the temperature rise for typical PCB constructions.
Note that R_DS(ON) increases with temperature, so as the device heats, the power dissipation increases. Take this
into consideration when sizing the heatsink.
10.3.2 Heatsinking
The PowerPAD™ package uses an exposed pad to remove heat from the device. For proper operation, this pad
must be thermally connected to copper on the PCB to dissipate heat. On a multi-layer PCB with a ground plane,
this can be accomplished by adding a number of vias to connect the thermal pad to the ground plane. On PCBs
without internal planes, copper area can be added on either side of the PCB to dissipate heat. If the copper area
is on the opposite side of the PCB from the device, thermal vias are used to transfer the heat between top and
bottom layers.
For details about how to design the PCB, refer to TI application report, PowerPAD™ Thermally Enhanced
Package (SLMA002) and TI application brief, PowerPAD™ Made Easy, (SLMA004) available at www.ti.com.
In general, the more copper area that can be provided, the more power can be dissipated. Figure 21 shows
thermal resistance versus copper plane area for both a single-sided PCB with 2-oz copper heatsink area, and a
4-layer PCB with 1-oz copper and a solid ground plane. Both PCBs are 76 mm × 114 mm, and 1.6-mm thick.
The heatsink effectiveness increases rapidly to about 20 cm², then levels off somewhat for larger areas.
Six pins on the center of each side of the package are also connected to the device ground. A copper area can
be used on the PCB that connects to the PowerPAD as well as to all the ground pins on each side of the device.
This is especially useful for single-layer PCB designs.
22
Submit Documentation Feedback
Product Folder Links: DRV8823
Copyright © 2009–2016, Texas Instruments Incorporated