74ACT11874 Datasheet, PDF (2/7 Pages) Texas Instruments – DUAL 4-BIT D-TYPE EDGE-TRIGGERED FLIP-FLOPS WITH 3-STATE OUTPUTS

74ACT11874
DUAL 4ĆBIT DĆTYPE EDGEĆTRIGGERED FLIPĆFLOPS
WITH 3ĆSTATE OUTPUTS
SCAS212 − D3447, MARCH 1990 − REVISED APRIL 1993
logic symbol^†
logic diagram (each 4-bits) (positive logic)
28
1OE
1
1CLK
27
1CLR
23
1D1
22
1D2
21
1D3
20
1D4
EN
C1
R
1D 1
2
1Q1
3
1Q2
4
1Q3
5
1Q4
OE
CLK
CLR
D1
R
Q1
C1
1D
15
2OE
14
2CLK
16
2CLR
20
2D1
19
2D2
18
2D3
17
2D4
EN
C1
R
1D 1
D2
10
2Q1
11
2Q2
12
2Q3
13
2Q4
D3
† _{This symbol is in accordance with ANSI/IEEE Std 91-1984}
and IEC Publication 617-12.
D4
R
Q2
C1
1D
R
Q3
C1
1D
R
Q4
C1
1D
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)^†
Supply voltage range, V_CC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −0.5 V to 7 V
Input voltage range, V_I (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −0.5 V to V_CC + 0.5 V
Output voltage range, V_O (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −0.5 V to V_CC + 0.5 V
Input clamp current, I_IK (V_I < 0 or V_I > V_CC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 20 mA
Output clamp current, I_OK (V_O < 0 or V_O > V_CC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 50 mA
Continuous output current, I_O (V_O = 0 to V_CC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 50 mA
Continuous current through V_CC or GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 200 mA
Storage temperature range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . − 55°C to 150°C
† _{Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only and}
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: The input and output voltage ratings may be exceeded if the input and output current ratings are observed.
2−2
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
• POST OFFICE BOX 1443 HOUSTON, TEXAS 77001