English
Language : 

LMH0036 Datasheet, PDF (11/19 Pages) National Semiconductor (TI) – SD SDI Reclocker with 4:1 Input Multiplexer
LMH0036
www.ti.com
SNLS254B – MARCH 2008 – REVISED APRIL 2013
APPLICATION INFORMATION
Figure 5 shows a application circuit for the LMH0036.
SCO_EN
SEL0
SEL1
VCC
56 nF
VCC
100:
Differential
Data Input 0
100:
Differential
Data Input 1
100:
Differential
Data Input 2
100:
Differential
Data Input 3
BP/ AUTO-BP
OP MUTE
1 SDI0
2
SDI0
3 VCC
4 SDI1
5
SDI1
6 VCC
7 SDI2
8
SDI2
9 VCC
10 SDI3
11
SDI3
12 VCC
VCC
LMH0036
36
SD
VCC
VCC
35
34
33
SDO
32
SDO
VCC 31
VCC
30
29
SCO/SDO2
28
SCO/SDO2
VEE 27
VEE 26
VEE 25
DAP
27 MHz
39 pF
39 pF
SD
Data
Output
Clock Output or
2nd Data Output
LOCK DET
Figure 5. Application Circuit
BYPASS/AUTO BYPASS has an internal pulldown to enable Auto Bypass mode by default. This pin may be
pulled high to force the LMH0036 to bypass all data.
OUTPUT MUTE has an internal pullup to enable the outputs by default. This pin may be pulled low to mute the
outputs.
The XTAL IN/EXT CLK and XTAL OUT pins are shown with a 27 MHz crystal and the proper loading. The crystal
should match the parameters described in Table 3. Alternately, a 27MHz LVCMOS compatible clock signal may
be input to XTAL IN/EXT CLK.
The active high LOCK DETECT output provides an indication that proper data is being received and the PLL is
locked.
The SD output may be used to drive the SD/HD pin of an SDI cable driver (such as the LMH0002) in order to
properly set the cable driver’s edge rate for SMPTE compliance. It defaults to low when the LMH0036 is not
locked.
Copyright © 2008–2013, Texas Instruments Incorporated
Product Folder Links: LMH0036
Submit Documentation Feedback
11