SBAU202 Datasheet, PDF (10/47 Pages) Texas Instruments – Performance Demonstration Kit for the ADS130E08

SOFTWARE INSTALLATION
www.ti.com
2.3.2 Installing the Second USB Driver
Launch the ADS130E08EVM-PDK software from the program menu. The software loads and begins
downloading firmware to the processor on the MMB0. After the firmware is loaded and running, the Found
New Hardware Wizard starts again, as shown in Figure 10.
Figure 10. Second New Hardware Wizard Screen
Click Next and the screen in Figure 11 appears.
Figure 11. Installing the USBStyx Driver
Click Next to complete the installation. If the computer is unable to find the USBStyx driver, point to the
installation directory of C:\Program Files\ADS130E08EVM\USB Drivers.
At this time, you may receive an error message because the ADS130E08EVM-PDK software has timed
out. If so, click OK, close the GUI program, power cycle the ADS130E08EVM, and restart the newly
installed ADS130E08 evaluation program. This process may need to be repeated if you plug the
ADS130E08EVM-PDK into a different USB port on your computer.
10
Performance Demonstration Kit for the ADS130E08
Copyright © 2012, Texas Instruments Incorporated
SBAU202 – June 2012
Submit Documentation Feedback