CC3120 Datasheet, PDF (10/57 Pages) Texas Instruments – SimpleLink Wi-Fi Wireless Network Processor Internet-of-Things Solution for MCU Applications

CC3120
SWAS034 – FEBRUARY 2017
www.ti.com
4 Specifications
All measurements are referenced at the device pins, unless otherwise indicated. All specifications are over
process and voltage, unless otherwise indicated.
4.1 Absolute Maximum Ratings
over operating free-air temperature range (unless otherwise noted)
VBAT and VIO
VIO – VBAT (differential)
Digital inputs
RF pins
Analog pins, XTAL
Operating temperature, T_A
Storage temperature, T_stg
Pins: 37, 39, 44
Pins: 10, 54
Pins: 22, 23, 51, 52
MIN
MAX UNIT
–0.5
3.8
V
0.0
V
–0.5
–0.5
V_IO + 0.5
V
2.1
V
–0.5
2.1
V
–40
85
°C
–55
125
°C
4.2 ESD Ratings
V_ESD
Electrostatic discharge
Human body model (HBM), per ANSI/ESDA/JEDEC JS-001⁽¹⁾
Charged device model (CDM), per JEDEC specification JESD22-C101⁽²⁾
VALUE
±2000
±500
(1) JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process.
(2) JEDEC document JEP157 states that 250-V CDM allows safe manufacturing with a standard ESD control process.
4.3 Power-On Hours
UNIT
V
NOTE
This information is provided solely for your convenience and does not extend or modify the
warranty provided under TI's standard terms and conditions for TI semiconductor products.
CONDITIONS
POH
T_A up to 85°C⁽¹⁾
87,600
(1) The TX duty cycle (power amplifier ON time) is assumed to be 10% of the device POH. Of the remaining 90% of the time, the device
can be in any other state.
4.4 Recommended Operating Conditions
over operating free-air temperature range (unless otherwise noted)⁽¹⁾⁽²⁾
VBAT, VIO
(shorted to VBAT)
Pins: 10, 37, 39,
44, 54
Direct battery connection⁽³⁾
Preregulated 1.85 V⁽⁵⁾⁽⁶⁾
MIN
2.1 ⁽⁴⁾
TYP
MAX UNIT
3.3
3.6
V
Ambient thermal slew
–20
20 °C/minute
(1) Operating temperature is limited by crystal frequency variation.
(2) When operating at an ambient temperature of over 75°C, the transmit duty cycle must remain below 50% to avoid the auto-protect
feature of the power amplifier. If the auto-protect feature triggers, the device takes a maximum of 60 seconds to restart the transmission.
(3) To ensure WLAN performance, ripple on the 2.1- to 3.3-V supply must be less than ±300 mV.
(4) The minimum voltage specified includes the ripple on the supply voltage and all other transient dips. The brownout condition is also 2.1
V, and care must be taken when operating at the minimum specified voltage.
(5) To ensure WLAN performance, ripple on the 1.85-V supply must be less than 2% (±40 mV).
(6) TI recommends keeping VBAT above 1.85 V. For lower voltages, use a boost converter.
10
Specifications
Submit Documentation Feedback
Product Folder Links: CC3120
Copyright © 2017, Texas Instruments Incorporated