TL16PNP100A Datasheet, PDF (8/20 Pages) Texas Instruments – STANDALONE PLUG-AND-PLAY (PnP) CONTROLLER

TL16PNP100A
STANDALONE PLUG-AND-PLAY (PnP) CONTROLLER
SLLS200C – MARCH 1995 – REVISED SEPTEMBER 1997
APPLICATION INFORMATION
on-board EEPROM programming
This section describes a simple approach to programming the resource EEPROM in an expansion board that
uses the TL16PNP100A. This approach involves utilizing a readily available standard EEPROM programmer
and a ribbon cable in addition to minor additions to the expansion board.
hardware required for programming an expansion board EEPROM
The hardware required for programming an expansion board EEPROM is listed in the following bulleted list and
shown in Figure 2.
D Ribbon cable with DB25 connector
D On-board ribbon connector and two jumper wires
SCLK
SCS
SI0
TL16PNP100A
R1
J1
2C
1
S
3D
4
Q
8
VCC ₇
DU
6
ORG
5
VSS
ST93C56166
VCC
J2
Ca
Expansion
Board
Connector
14
21
DB25 Connector
Parallel PC
11
Printer Port
7 (see Page 2 For pinout)
8
9
Figure 2. Programming an Expansion Board EEPROM
8
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265