|
BQ24257 Datasheet, PDF (33/45 Pages) Texas Instruments – 2A Single Input I2C, Standalone Switch-Mode Li-Ion Battery Charger with Integrated Current Sense Resistor | |||
|
◁ |
www.ti.com
bq24257
bq24258
SLUSBG0B â FEBRUARY 2013 â REVISED JULY 2013
Register #7
Memory location: 06, Reset state: 1110 0000 for the bq24258 and 0010 0000 for the bq24257.
BIT
NAME
Read/Write
FUNCTION
B7(MSB)
B6
B5
VOVP_2
VOVP_1
VOVP_0
Read/Write
Read/Write
Read/Write
OVP voltage:
000 â 6.0V; 001 â 6.5V; 010 â 7.0V; 011 â 8.0V
100 â 9.0V; 101 â 9.5V; 110 â 10.0V; 111 â10.5V
B4
CLR_VDP
Read/Write 0 â Keep D+ voltage source on during DBP charging
1 â Turn off D+ voltage source to release D+ line
B3
FORCE_BATDET Read/Write 0 â Enter the battery detection routine only if TERM is true or EN_PTM is true
1 â Enter the battery detection routine
B2
FORCE_PTM
Read/Write 0 â PTM mode is disabled
1 â PTM mode is enabled if OTP_EN_PTM=1
B1
N/A
Read/Write
B0(LSB)
N/A
Read/Write
⢠VOVP â Sets the OVP level
⢠CLR_VDP â When the D+/Dâ detection has finished, some cases require the D+ pin to force a voltage of
0.6V. This bit allows the system to clear the voltage prior to any communication on the D+/Dâ pins. A â1â
clears the voltage at the D+ pin if present.
⢠FORCE_BATDET â Forces battery detection and provides status of the battery presence. A logic â1â enables
this function.
⢠FORCE_PTM â Puts the device in production test mode (PTM) where the input current limit is disabled. Note
that a battery must not be present prior to using this function. Otherwise the function will not be allowed to
execute. A logic â1â enables the PTM function.
Copyright © 2013, Texas Instruments Incorporated
Product Folder Links: bq24257 bq24258
Submit Documentation Feedback
33
|
▷ |