English
Language : 

SN74ALVCH16831 Datasheet, PDF (3/9 Pages) Texas Instruments – 1-TO-4 ADDRESS REGISTER/DRIVER WITH 3-STATE OUTPUTS
◁
www.ti.com
ABSOLUTE MAXIMUM RATINGS(1)
over operating free-air temperature range (unless otherwise noted)
SN74ALVCH16831
1-TO-4 ADDRESS REGISTER/DRIVER
WITH 3-STATE OUTPUTS
SCES083F – AUGUST 1996 – REVISED SEPTEMBER 2004
VCC
Supply voltage range
VI
Input voltage range(2)
VO
Output voltage range(2)(3)
IIK
Input clamp current
IOK
Output clamp current
IO
Continuous output current
Continuous current through each VCC or GND
θJA
Package thermal impedance(4)
Tstg
Storage temperature range
VI < 0
VO < 0
MIN
MAX UNIT
-0.5
4.6 V
-0.5
4.6 V
-0.5 VCC + 0.5
V
-50 mA
-50 mA
±50 mA
±100 mA
64 °C/W
-65
150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended
operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.
(3) This value is limited to 4.6 V, maximum.
(4) The package thermal impedance is calculated in accordance with JESD 51-7.
RECOMMENDED OPERATING CONDITIONS(1)
VCC
Supply voltage
VIH
High-level input voltage
VIL
Low-level input voltage
VI
Input voltage
VO
Output voltage
IOH
High-level output current
IOL
Low-level output current
∆t/∆v
TA
Input transition rise or fall rate
Operating free-air temperature
VCC = 1.65 V to 1.95 V
VCC = 2.3 V to 2.7 V
VCC = 2.7 V to 3.6 V
VCC = 1.65 V to 1.95 V
VCC = 2.3 V to 2.7 V
VCC = 2.7 V to 3.6 V
VCC = 1.65 V
VCC = 2.3 V
VCC = 2.7 V
VCC = 3 V
VCC = 1.65 V
VCC = 2.3 V
VCC = 2.7 V
VCC = 3 V
MIN
1.65
0.65 × VCC
1.7
2
0
0
-40
MAX
3.6
0.35 × VCC
0.7
0.8
VCC
VCC
-4
-12
-12
-24
4
12
12
24
10
85
UNIT
V
V
V
V
V
mA
mA
ns/V
°C
(1) All unused control inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
3
 ▷