TMS320C6745 Datasheet, PDF (200/209 Pages) Texas Instruments – Floating-point Digital Signal Processor

TMS320C6745/6747 Floating-point Digital Signal Processor
SPRS377A – SEPTEMBER 2008 – REVISED OCTOBER 2008
www.ti.com
Module State
Auto Wake
Module Reset
De-asserted
Table 6-101. Module States (continued)
Module Clock
Off
Module State Definition
A module in the Auto Wake state also has its module reset de-asserted and its
module clock disabled, similar to the Disable state. However this is a special
state, once a module is configured in this state by software, it will
“automatically” transition to “Enable” state whenever there is an internal
read/write request made to it, and will remain in the “Enabled” state from then
on (with module reset re de-asserted and module clock on), without any
software intervention. The transition from sleep to enabled state has some
cycle latency associated with it. It is not envisioned to use this mode when
peripherals are fully operational and moving data.
6.34 Real Time Clock (RTC)
The RTC provides a time reference to an application running on the device. The current date and time is
tracked in a set of counter registers that update once per second. The time can be represented in 12-hour
or 24-hour mode. The calendar and time registers are buffered during reads and writes so that updates do
not interfere with the accuracy of the time and date.
Alarms are available to interrupt the CPU at a particular time, or at periodic time intervals, such as once
per minute or once per day. In addition, the RTC can interrupt the CPU every time the calendar and time
registers are updated, or at programmable periodic intervals.
The real-time clock (RTC) provides the following features:
• 100-year calendar (xx00 to xx99)
• Counts seconds, minutes, hours, day of the week, date, month, and year with leap year compensation
• Binary-coded-decimal (BCD) representation of time, calendar, and alarm
• 12-hour clock mode (with AM and PM) or 24-hour clock mode
• Alarm interrupt
• Periodic interrupt
• Single interrupt to the CPU
• Supports external 32.768-kHz crystal or external clock source of the same frequency
• Separate isolated power supply
Figure 6-67 shows a block diagram of the RTC.
RTC_XI
XTAL
RTC_XO
Counter
32 kHz
Oscillator
Compensation
Week
Days
Oscillator
Seconds
Minutes Hours
Days
Months
Years
Alarm
Timer
Figure 6-67. Real-Time Clock Block Diagram
Alarm
Interrupts
Periodic
Interrupts
200 Peripheral Information and Electrical Specifications
Submit Documentation Feedback