English
Language : 

THS4511 Datasheet, PDF (15/25 Pages) Texas Instruments – WIDEBAND, LOW NOISE, LOW DISTORTION FULLY DIFFERENTIAL AMPLIFIER
www.ti.com
S-Parameter, Slew Rate, Transient Response, Set-
tling Time, Output Impedance, Overdrive, Output
Voltage, and Turn-On/Off Time
The circuit shown in Figure 40 is used to measure
s-parameters, slew rate, transient response, settling
time, output impedance, overdrive recovery, output
voltage swing, and turn-on/turn-off times of the ampli-
fier. For output impedance, the signal is injected at
VOUT with VIN left open and the drop across the 49.9
Ω resistor is used to calculate the impedance seen
looking into the amplifier’s output.
Because S21 is measured single-ended at the load
with 50-Ω double termination, add 12 dB to refer to
the amplifier’s output as a differential signal.
From VIN
50-W
Source
RG
R IT
0.22 mF
49.9 W
RG
R IT
RF
5V
THS4511
CM
RF
49.9 W
49.9 W
Open
0.22 mF
VOUT+
VOUT-
To 50-W
Test
Equipment
Figure 40. S-Parameter, SR, Transient Response,
Settling Time, ZO, Overdrive Recovery, VOUT
Swing, and Turn-on/off Test Circuit
CM Input
The circuit shown in Figure 41 is used to measure the
frequency response and input impedance of the CM
input. Frequency response is measured single-ended
THS4511
SLOS471 – SEPTEMBER 2005
at VOUT+ or VOUT– with the input injected at VIN, RCM =
0 Ω and RCMT = 49.9 Ω. The input impedance is
measured with RCM = 49.9 Ω with RCMT = open, and
calculated by measuring the voltage drop across RCM
to determine the input current.
0.22 mF
49.9 W
0.22 mF
49.9 W
RG
RIT
RG
RIT
RF
5V
THS4511
CM
RF
49.9 W
49.9 W
RCM
RCMT
VOUT–
To
50-W
Test
VOUT+ Equipment
VIN From
50-W
source
Figure 41. CM Input Test Circuit
CMRR and PSRR
The circuit shown in Figure 42 is used to measure the
CMRR and PSRR of VS+ and VS–. The input is
switched appropriately to match the test being per-
formed.
VS+
PSRR+
From VIN
50 W
Source
CMRR
PSRR-
VS-
348 W
5V
100 W
100 W
THS4511
CM
69.8 W
49.9 W
49.9 W 100 W
Open
0.22 mF
Output
Measured
Here
With High
Impedance
Differential
Probe
348 W
Figure 42. CMRR and PSRR Test Circuit
15