TLC220X Datasheet, PDF (14/62 Pages) Texas Instruments – Advanced LinCMOSE LOW-NOISE PRECISION OPERATIONAL AMPLIFIERS

TLC220x, TLC220xA, TLC220xB, TLC220xY
Advanced LinCMOS™ LOW-NOISE PRECISION
OPERATIONAL AMPLIFIERS
SLOS175 – FEBRUARY 1997
TLC2202C electrical characteristics at specified free-air temperature, V_DD± = ±5 V (unless
otherwise specified)
PARAMETER
TEST CONDITIONS
VIO
α_VIO
Input offset voltage
Temperature coefficient of input offset voltage
Input offset voltage long-term drift (see Note 4)
VIC = 0,
IIO
Input offset current
IIB
Input bias current
VIC = 0,
RS = 50 Ω
RS = 50 Ω
TA†
25°C
Full range
Full range
25°C
25°C
Full range
25°C
Full range
TLC2202C
MIN TYP MAX
100 1000
1150
0.5
0.001 0.005
0.5
100
1
100
UNIT
µV
µV/°C
µV/mo
pA
VICR Common-mode input voltage range
RS = 50 Ω
–5
Full range
to
V
2.7
VOM ₊ Maximum positive peak output voltage swing
VOM _– Maximum negative peak output voltage swing
RL = 10 kΩ
25°C
4.7 4.8
Full range
4.7
V
25°C
– 4.7 – 4.9
Full range – 4.7
V
VO = ± 4 V, RL = 500 kΩ
AVD Large-signal differential voltage amplification
VO = ± 4 V, RL = 10 kΩ
25°C
Full range
25°C
Full range
300 560
200
50 100
25
V/mV
CMRR Common-mode rejection ratio
VO = 0,
VIC = VICRmin,
25°C
RS = 50 Ω
Full range
80 115
80
dB
25°C
80 110
kSVR Supply-voltage rejection ratio (∆VDD _± /∆VIO) VDD _± = ± 2.3 V to ± 8 V
Full range
80
dB
IDD Supply current
VO = 0,
No load
25°C
Full range
1.8 2.7
mA
2.7
† _{Full range is 0°C to 70°C.}
NOTE 4: Typical values are based on the input offset voltage shift observed through 168 hours of operating life test at TA = 150 °C extrapolated
to TA = 25 °C using the Arrhenius equation and assuming an activation energy of 0.96 eV.
TLC2202C operating characteristics at specified free-air temperature, V_DD± = ±5 V
PARAMETER
TEST CONDITIONS
TA†
TLC2202C
UNIT
MIN TYP MAX
SR
Slew rate at unity gain
VO = ± 2.3 V,
CL = 100 pF
RL = 10 kΩ,
25°C
Full range
1.8 2.7
1.3
V/µs
Vn
Equivalent input noise voltage
f = 10 Hz
f = 1 kHz
25°C
25°C
18
8
nV/√Hz
f = 0.1 to 1 Hz
VN(PP) Peak-to-peak equivalent input noise voltage _{f = 0.1 to 10 Hz}
25°C
25°C
0.5
µV
0.7
In
Equivalent input noise current
25°C
0.6
fA/√Hz
Gain-bandwidth product
f = 10 kHz,
CL = 100 pF
RL = 10 kΩ,
25°C
1.9
MHz
φ_m
Phase margin at unity gain
† _{Full range is 0°C to 70°C.}
RL = 10 kΩ,
CL = 100 pF
25°C
48°
14
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265