TC213 Datasheet, PDF (13/21 Pages) Texas Instruments – 1024- × 512-pixel ccd image sensor

TC213
1024- × 512-PIXEL CCD IMAGE SENSOR
SOCS013B – AUGUST 1989 – REVISED DECEMBER 1991
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)^†
Supply voltage range for ADB, CDB, IDB, TDB (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 V to 15 V
Input voltage range for ABGI, ABGS, IAG, RST1, RST2, SAG, SRG1, SRG2, TRG . . . . . . . . –15 V to 15 V
Operating free-air temperature range, T_A . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –10°C to 40°C
Storage temperature range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –30°C to 85°C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C
† _{Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and}
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: All voltage values are with respect to the substrate terminal.
recommended operating conditions
MIN NOM MAX UNIT
Supply voltage for ADB, CDB, IDB, TDB
11
12
13 V
Substrate bias voltage
0
V
High level
1.5
2 2.5
IAG
Low level
–11
–9
SAG
High level
Low level
1.5
2 2.5
–11
–9
Input voltage, VI‡
SRG
RST1, RST2
High level
Low level
High level
Low level
1.5
2 2.5
–11
–9
1.5
2 2.5 V
–11
–9
High level (ABGI only)
5 5.5
6
ABGI, ABGS
Intermediate level§
–1.5 –1. 2 – 0.9
Low level
–7.5 –7 – 6.5
TRG
High level
Low level
1.5
2 2.5
–11
–9
RST1, RST2, SRG1, SRG2, TRG
10
Clock frequency, fclock IAG, SAG
ABGI, ABGS
1
MHz
1
Capacitive load
OUT1, OUT2
8 pF
Operating free-air temperature, TA
– 10
40 °C
‡ _{The algebraic convention, in which the least-positive (most negative) value is designated minimum, is used in this data sheet for clock voltage}
levels.
§ _{Adjustment is required for optimal performance.}
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
2-13