|
LP2989LV_15 Datasheet, PDF (1/26 Pages) Texas Instruments – Micropower and Low-Noise, 500-mA Ultra Low-Dropout Regulator for Use With Ceramic Output Capacitors | |||
|
Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
LP2989LV
SNVS086K â MAY 2000 â REVISED JULY 2015
LP2989LV Micropower and Low-Noise, 500-mA Ultra Low-Dropout Regulator for Use With
Ceramic Output Capacitors
1 Features
â¢1 2.1-V to 16-V Input Voltage Range
⢠Ultra-Low Dropout Voltage
⢠500-mA Continuous Output Current
⢠Very Low Output Noise With External Capacitor
⢠< 0.8-µA Quiescent Current When Shut Down
⢠Low Ground Pin Current at All Loads
⢠0.75% Output Voltage Accuracy (A Grade)
⢠High Peak Current Capability (800-mA typical)
⢠Overtemperature and Overcurrent Protection
⢠â40°C to +125°C Junction Temperature Range
2 Applications
⢠Notebooks and Desktop PCs
⢠PDAs and Palmtop Computers
⢠Wireless Communication Pins
⢠SMPS Post-Regulators
3 Description
The LP2989LV is a fixed-output 500-mA precision
LDO regulator designed for use with ceramic output
capacitors.
Output noise can be reduced to 18 μV (typical) by
connecting an external 10-nF capacitor to the bypass
pin.
Using an optimized Vertically Integrated PNP (VIP)
process, the LP2989LV delivers superior
performance:
Ground Pin Current: Typically 3 mA at 500-mA load,
and 110 µA at 100-µA load.
Sleep Mode: The LP2989LV draws less than 0.8-µA
quiescent current when SHUTDOWN pin is pulled
low.
ERROR Flag: The built-in ERROR flag goes low
when the output drops approximately 5% below
nominal.
Precision Output: Output voltage accuracy is 0.75%
(A grade) and 1.25% (standard grade) at room
temperature.
For output voltages greater than or equal to 2 V, see
the LP2989 (SNVS083) data sheet.
Device Information(1)
PART NUMBER PACKAGE
BODY SIZE (NOM)
LP2989LV
WSON (8)
SOIC (8)
4.00 mm x 4.00 mm
4.90 mm x 3.91 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
Typical Application
*Capacitance values shown are minimum required to assure stability, but may be increased without limit. Larger
output capacitor provides improved dynamic response. See the Output Capacitor section.
**Shutdown must be actively terminated (see the Shutdown Input Operation section). Tie to IN (pin 4) if not use.
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.
|
▷ |