DRV3203-Q1_15 Datasheet, PDF (1/37 Pages) Texas Instruments – Three-Phase Brushless Motor Driver

DRV3203-Q1
www.ti.com
SLVSC09A – MAY 2013 – REVISED JUNE 2013
Three-Phase Brushless Motor Driver
Check for Samples: DRV3203-Q1
FEATURES
1
• 3-Phase Pre-Drivers for N-Channel MOS Field-
Effect Transistors (MOSFETs)
• Pulse-Width Modulation (PWM) Frequency up
to 20 kHz
• Fault Diagnostics
• Charge Pump
• Phase Comparators
• Microcontroller (MCU) Reset Generator
• Serial Port I/F (SPI)
• Motor-Current Sense
• 3.3-V Regulator
• Low-Current Sleep Mode
• Operation VB Range From 5.3 to 28.5 V
• AEC-Q100 Grade 1 -40°C to +125°C Ambient
Operating Temperature
• 48-Pin PHP
DESCRIPTION
The DRV3203-Q1 device is a field-effect transistor
(FET) pre-driver designed for three-phase motor
control for applications such as an oil pump or a
water pump. The device has three high-side pre-FET
drivers and three low-side drivers which are under the
control of an external MCU. A charge pump supplies
the power for the high side, and there is no
requirement for a bootstrap capacitor. For
commutation, this integrated circuit (IC) sends a
conditional motor signal and output to the MCU.
Diagnostics provide undervoltage, overvoltage,
overcurrent, overtemperature and power-bridge
faults. One can measure the motor current using an
integrated current-sense amplifier and comparator in
a battery common-mode range, which allows the use
of the motor current in a high-side current-sense
application. External resistors set the gain. One can
configure the pre-drivers and other internal settings
through the SPI.
APPLICATIONS
• Oil Pump
• Fuel Pump
• Water Pump
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2013, Texas Instruments Incorporated