|
U6239B Datasheet, PDF (2/15 Pages) TEMIC Semiconductors – 2.9 GHz PLL for SAT TV Tuner with UNi-Bus | |||
|
◁ |
U6239B
Ordering Information
Extended Type Number
U6239B-AFPG3
Package
SO16, plastic package
Remarks
Taped and reeled
SSO16 package on request
Pin Configuration
PD 1
Q1 2
RDS/AMS 3
SDA 4
SCL 5
P7 6
P6/ ADC 7
P5 8
16 VD
15 GND
Pin Symbol
Function
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 1
PD
Charge pump output
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 2
Q1
Crystal input
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 3
RDS/ Reference divider select input
AMS (3-wire bus mode)
Address mode select input
95 10947
14 RFi
13 RFi
12 VS
11 P0/ Lock
10 AS/ENABLE/
P3
9 P4
(I2C bus mode)
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 4
SDA Data input/ output
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 5
SCL Clock input
6
P7
Port 7 input/ output
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 7
P6/
Port 6 output
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ ADC Analog-Digital-Converter input
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 8
P5
Port 5 input/ output
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 9
P4
Port 4 input/ output
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 10
AS/
Address select input
ENABLE/ Enable input
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ P3
Port 3 output
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 11 P0/Lock Port 0 output/Lock output
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 12
VS
Supply voltage
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 13
RFi
RF input
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 14
RFi
RF input
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 15
GND Ground
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃ 16
VD
Active filter output
Circuit Description
The U6239B is a single-chip PLL designed for SAT TV
tuner and cable tuner. It consists of a divide-by-16
prescaler with an integrated preamplifier, a 15-bit
programmable divider, a crystal oscillator, and a
reference divider with selectable divider ratios, a phase/
frequency detector together with a charge pump which
drives the tuning amplifier. Only one external transistor
is required for varactor line driving. The device can be
controlled via I2C bus format or via 3-wire bus format. It
detects automatically which bus format has been
received. Therefore, there is no need for a bus selection
pin. In I2C bus mode, the device has four programmable
or one fixed and three programmable I2C bus addresses,
depending on the voltage level at Pin 3. They are
programmed by applying a specific input voltage to the
address select input Pin 10, enabling the use of up to four
synthesizers in a system. If the fixed address is used, this
pin can be used as a normal output port. The same pin
serves as the enable signal input in 3-wire bus mode.
Depending whether the fixed address is used or not there
are five or six open collector outputs for switching
functions available. In 3-wire bus mode there are four
open collector outputs and one lock signal output. All
open collector outputs are capable of sinking at least
10 mA. In I2C bus mode an analog-to-digital converter
(ADC) is available for digital AFC (automatic frequency
control) applications and the ports P4, P5 and P7 can also
be used as input ports.
2 (15)
TELEFUNKEN Semiconductors
Rev. A3, 28-May-97
|
▷ |